Is the Sealed, 3-Light Truck, Trailer Identification LED Light Bar # MCL93RB Street Legal
Question:
Is this light DOT approved as a marker/clearance light? We are wanting to use this on the back of a box truck at the top replacing our incandescent bulbs.
asked by: Darrin
0
Expert Reply:
Yes, the Sealed, 3-Light Truck, Trailer Identification LED Light Bar # MCL93RB is rated for use as a marker/clearance light at the back of your box truck.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
LED Identification Light Bar for Trailers over 80" Wide - Submersible - 9 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Rear Clearance
- ID Bar
- Surface Mount
- Submersible Lights
- LED Light
- 15-15/16L x 1-1/2W Inch
- Red
- Optronics
more information >
Continue Researching
- Article: How to Charge a Dump Trailer Battery
- Q&A: Installation Instructions for Bulldog Powered-Drive Kit # BD1824200100
- Q&A: Recommended Lithium Battery Compatible Power Converter For Parallax 7355
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Grease Seal to Replace 127194TB
- Q&A: Replacement Parts for ELX-45 Power Converter
- Q&A: Replacement Trailer Hub/Drum for Part Number 2420801
- Q&A: Replacement Leaf Spring Bolts and Bushings for Dexter 10K Axle On Big Tex Trailer
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Trailer Hitch Receiver Sizes
- Q&A: Is There Down Side to Progressive Dynamics 4000 Series 60 Amp Over 45 Amp
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Trailer Wiring Diagrams
- Article: Roadmaster Vehicle Specific Base Plates