Can Erickson Horizontal E-Track # EM19147 be Used on Plywood
Question:
Can this track be installed on a 3/4inch plywood trailer floor and still maintain the 2000lbs working limit? Or will it need backin plates.?
asked by: Gilbert P
0
Expert Reply:
If you used at least every other mounting hole to secure the E-track part # EM19147 to the plywood and the wood itself was rated for the weight as well you'd be totally fine.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 4' Long - Qty 1
- E-Track
- E-Track Rails
- Horizontal
- 5 Inch Wide
- 2000 lbs
- 4 Feet Long
- Erickson
more information >
Continue Researching
- Article: How to Install E-Track in 3 Easy Steps
- Q&A: Availability of 6 Sets of 94 inch E-Track
- Article: Trailer Wiring Diagrams
- Q&A: Is E-track Stronger Than X-track, Is There An Advantage Of One Over The Other
- Q&A: Can E-Track be Driven Over and be Used to Secure Vehicle Tire To
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Q&A: What Hardware Should Be Used to Install etrailer Horizontal E-Track on Enclosed Trailer Wall
- Q&A: Hardware for Attaching E-Track to Wood Floor and Walls
- Article: How to Tie Down a Motorcycle
- Q&A: Recommended Hardware to Use for CargoSmart 5 Foot Long X-Tracks
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: Where to Position the Trailer Axle?