What is Needed to Install the Yakima RocketBox Pro 14 Cargo Box on a 2011 Dodge Journey

Question

Question:

Will it fit on my Dodge Journey 2011

asked by: Skschmidt

0

Expert Reply:

The Yakima RocketBox Pro 14 Cargo Box, part # Y07192, will fit your 2011 Dodge Journey if you have the factory roof rack with cross bars that run from side to side.

If your 2011 Dodge Journey has just the factory installed side rails that run from front to back you will need to use the Inno Square Bar Roof Rack, parts # INB127 and # INFR. These parts will attach to your factory side rails and supply the cross bars that are needed for attachment of the Yakima RocketBox cargo box.

The last option is if your 2011 Dodge Journey has a naked roof (no side rails or cross bars) you will need to use the Yakima Crossbars # Y00426, the BaseLine Towers # Y28TR, and the BaseClips # Y06110 and # Y06126. This setup will give you the needed roof rack for the Yakima RocketBox.

Anytime you are going to haul cargo on the roof of your 2011 Dodge Journey you will want to check the owners manual or with the Dodge dealer for what the roof capacity is for your vehicle. The roof capacity will let you know how many pounds you will be able to haul on the roof of your vehicle.

I am including a link to the installation instructions on the Yakima RocketBox.

expert reply by: Jeff D

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 4

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 5

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 6

While we may have an option for you, we do not have the exact specs on your Allis grease seal part number 5013 29772. However, with the 1.6" ID and 2.5" OD measurements you provides, that is very close to our #58846. This particular grease…

view full answer...

Answer 7

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 10

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…

view full answer...

What is Needed to Install the Yakima RocketBox Pro 14 Cargo Box on a 2011 Dodge Journey

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching