Where is the Connector Needed to Install a Hopkins Wiring Kit # 43105 in a 2003 Acura TL
Question:
I cant find it on my Acura TL Types S 2003 Thanks in advance.
asked by: Bob Z
0
Expert Reply:
The OEM connector that you need to find to install the Plug-N-Tow TM Vehicle Wiring Harness, part # 43105, is located in the trunk behind the driver side taillight access panel.
The access panel is the piece of the interior that you would remove if you were trying to replace the tail light bulb.
It might not be in plain view, you might need to reach in there and see if you can feel around for it.
I attached the installation instructions for this product below for you to check out.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hopkins Plug-In Simple Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Converter
- Custom Fit
- 4 Flat
- Hopkins
more information >
Featured Help Information
Instructions
Continue Researching
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Trailer Hitch Receiver Fit For 2024 Toyota Corolla Hatchback
- Q&A: Replacement Hardware Kit Availability for Draw-Tite Trailer Hitch # 24790 for a 2000 Honda CR-V
- Q&A: Recommended Trailer Hitch Receiver, Wiring, And Ball Mount For 1998 Honda CR-V
- Q&A: How To Prevent Sag On 2004 Honda CR-V With Small Trailer
- Article: Must-Have Flat Towing Components
- Q&A: How to Determine If My RV Has Separate or Combined Lighting for Installation of Roadmaster Diodes
- Q&A: Difference Between Tekonsha Trailer Wiring Harnesses that Fit 2019 Honda Odyssey
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Roadmaster Vehicle Specific Base Plates
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch