Can Trailer Valet XL Push and Pull a Trailer to Move It

Question

Question:

I am looking at your Valet XL trailer dolly. I need it to push a 19foot Jon boat into the garage. The demo only shows the guy pulling. Does it go both ways Push/pull.

asked by: Michael P

0

Expert Reply:

The crank handle of the Trailer Valet XL Trailer Dolly # TVXL25 can be spun in either direction so it could push or pull a trailer if needed. In either direction it works just as good.

expert reply by: Jameson C

0

Nick

9/6/2020

What are the recommendations for the drill for using the drill attachment? Would the Dewalt DCD791 be enough to use the dolly at its maximum capacit? It has UWO of 450. Hard torque of 650 and about a third of that soft torque.

Reply

Jon G.

9/9/2020

Trailer Valet has the XL # TVXL25 paired with either the DCD740B or the DCD780B in their packages so you want something at least that powerful. You'll want to use the low gear setting for this application.

Reply

Answer 1

That is a great question. As you mentioned, the Trailer Valet XL Trailer Dolly with Chain Drive #TVXL25 has a gross trailer weight capacity of 10,000 pounds and a tongue weight capacity of 1,000 pounds. I reached out to my contact at Trailer Valet…

view full answer...

Answer 2

The best recommendation I can make would be to have the trailer attached to a tow vehicle so that the jack can be unsupported and you can easily access it. After that you'll need to unbolt the wheel assembly from the jack. Remove the valve…

view full answer...

Answer 3

As long as the tongue weight of the trailer is around 10-15 percent of the total trailer weight the Trailer Valet XL Trailer Dolly #TVXL25 is going to work like it was designed for. It does decently on flat surfaces and inclines but if it's…

view full answer...

Answer 4

I wish there was a way to free wheel the Trailer Valet. The only way to do that would be to install a second jack on the trailer that has a wheel caster on it which you could lower when you needed the ability to free wheel. Something like the…

view full answer...

Answer 5

Trailer Valet XL Trailer Dolly #TVXL25 will be able to move your trailer at the near 90 degree angle and up the incline of the driveway. The dolly has 2 gears and you will likely find that the low speed, 27 to 1 ratio will make it easier on you…

view full answer...

Answer 6

From your description, I'm assuming your FJ Cruiser has the factory equipped 4 pole trailer connector. To install a controller on your vehicle, you'd need our Brake Controller Installation Kit, part #ETBC7. You'll also need to…

view full answer...

Answer 7

Hey Antoine, so the two kits you mentioned are actually really similar and honestly I would go with the part #ETBC7 if I were you. The #ETBC7L is basically the same thing minus a couple wires and breakers so you may as well get the kit that has…

view full answer...

Answer 8

You wouldn't want to try and move a trailer up an incline with the MT70881. The dolly itself would be fine but you would most likely not be able to pull that heavy of a trailer up an incline. And then if you somehow did get it going up the…

view full answer...

Answer 9

Hey Frank, so the Blue Ox SwayPro weight distribution system you'd want is the part #BXW0750 which has a tongue weight range that matches what a 6,000 lb trailer would have.

view full answer...

Answer 10

I checked the manual and also reached out to Blue Ox to confirm this but found no notes and Blue Ox stated that the Blue Ox Base Plate Kit #BX1739 would be a compatible fit for your 2020 GMC Sierra 3500 (diesel). If you haven't picked out…

view full answer...

Answer 11

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 12

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Can Trailer Valet XL Push and Pull a Trailer to Move It

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching