Recommended Roof Rack Options For 2009 Toyota Matrix With Fixed Mounting Points

Question

Question:

I am planning on purchasing the rhino-rack 2500 to attach to my 2009 Toyota matrix fixed mounting points. The website defaults to recommending the part DK185 Custom DK Fit Kit for a naked roof installation. Do I need to buy a kit for the fixed roof installation? THANK YOU.

asked by: Daren S

0

Expert Reply:

For your 2009 Toyota Matrix the only style roof rack system is the clamp on style rather than bolting to fixed mounting points. I would recommned the Inno roof rack system with square bars that clamp securely to your roof. The # INB107 crossbars are mated with the # INSUT feet and # INK244 fit kit, and install easily. The square bars are heavy duty and work with most accessories.

You might also consider the Inno # INXB108-2, with # INXS250 feet, and # INK244 fit kit for a roof rack with low profile, and more aerodynamic Aero crossbars that have T-channels for accessories. Includes locks and keys.

expert reply by: Jason S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

Aside from a slight change in the appearance of the crossbar (the WingBar Evo has some boxed edges as opposed to the completely smooth front of the AeroBlade) the biggest differences are the rubber strip on top of the crossbar and the weight…

view full answer...

Answer 3

For the LCI52-SB-86.5-68.5, the two ending measurements are: 1st - measurement from hub to hub, meaning the length of the axle in this case is 86.5 inches. 2nd - spring seat dimension where they're welded, meaning the spring seats are 68.5 inches…

view full answer...

Answer 4

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

view full answer...

Answer 5

Hey Luke, Sorry about the confusion, and we can 100% get your 2007 Honda Civic 4-door sedan set up with all the parts needed for a Rhino-Rack roof rack, including both crossbars. You would just need these parts: - Rhino-Rack Vortex Aero Crossbars…

view full answer...

Answer 6

Hey John, I used to have a 2013 Sienna, it was a great van. I can definitely help set you up with Rhino Rack Vortex Aero Crossbars for your 2014 Sienna. The Rhino-Rack #RRVA126B-2 that you mentioned is a set of crossbars only though, so additional…

view full answer...

Answer 7

While we do not have any knowledge about options that come with vehicles, any decent or even middling car salesman should be able to tell you within seconds what does or does not come with a vehicle such as the 2019 Ford Edge. I highly recommend…

view full answer...

Recommended Roof Rack Options For 2009 Toyota Matrix With Fixed Mounting Points

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching