Needing a Faucet that has a Center Hole Only Installation

Question

Question:

can this faucet be used without its base plate?. My existing faucet has only the center hole installation.

asked by: Robert T

1

Helpful Expert Reply:

the Phoenix Faucets 8 Inch Single Handle RV Kitchen Faucet, # PF231321, might be the best option for your trailer's sink. This faucet is designed to be installed in either a one or three hole sink mount.

The Ultra Fab Faucet, # 277-000182, that you referenced can only be installed in a three hole sink mount. Therefore, this faucet is not compatible to your sink.

expert reply by: Jared P

1

Answer 1

The Phoenix Faucets #PF231321 would be a good choice regardless of if you're replacing a 1 or a 3 hole mount faucet. Escutcheons are included for both mounting options. I'll work great in your Roadtrek Class B motorhome. If you click the…

view full answer...

Answer 2

I typically just use a razor knife, like #PT92ZR, to cut out small chunks of caulk at a time until I can get the line free. Just be careful that you don't cut into the line if it's pex or some other soft tubing. The Phoenix Faucets Hybrid RV…

view full answer...

Answer 3

Thanks for the picture of your Phoenix Faucets Hybrid RV Kitchen Faucets #PF231321. It could be a couple of reasons your faucet is leaking, however the most common reasons faucets leak is due to an o-ring not being installed correctly or your water…

view full answer...

Answer 4

I went out to the warehouse to measure the line length on the Phoenix Faucets 8" Single Handle RV Kitchen Faucet #PF231321. Measuring from the end of the threaded shaft the lines are 9-1/2 inches long. Measured from the base of the faucet they…

view full answer...

Answer 5

Yes, the spout on the Phoenix Faucets 8" Single Handle RV Kitchen Faucet part #PF231321 does indeed swivel for use with double bowl sinks. The aerator on the end can be removed to flush the lines so I don't see any reason why you could not…

view full answer...

Answer 6

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 7

The number you provided, "7753400" is a patent number which corelates to the Equalizer for E-Z Flex Suspension part #013-144-03. This is for a single equalizer but if you need the entire kit it's the Dexter E-Z Flex Suspension Kit part…

view full answer...

Answer 8

I have a solution for you, but we do not carry Glo-Brite lights, so replacing it with the same brand will not be something I can offer you. Instead, to replace your Glo-Brite 9852-88, I recommend using the Optronics LED Trailer Tail Light #STL72RB.…

view full answer...

Answer 9

If your vehicle has a factory brake controller plug, you can simply use the Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers – Ford, Item #3034-P, which will connect to the vehicle plug and the brake controller. On the new E-450…

view full answer...

Answer 10

To see all of the correct wheel and tire combos you'd need check out the link I attached. The option I would recommend is the part #TA43RR which is a Load Range C tire size ST175/80R13 mounted on a white spoke wheel with a bolt pattern of 5 on…

view full answer...

Answer 11

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 12

Brake systems are not dependent on the hub bolt pattern. So you can use the Electric Trailer Brake Kit #AKEBRK-7-SA for 12 inch hub/drums or #AKEBRK-35-SA for 10 inch hub/drums. Then use #10-1-1 wire sold by the foot for your brake magnet wiring.…

view full answer...

Needing a Faucet that has a Center Hole Only Installation

Products Referenced in This Question

Featured Help Information

Miscellaneous Media

Continue Researching