what is the diameter of the Pin on the Etrailer Topwind Weld-On Swivel Jack
Question:
could you tell me what the pin diameter is on the pipe mount thanks
asked by: Ken S
0
Expert Reply:
The pin in the Etrailer Weld-On Swivel Jack, # TJP-2001-B, measures 1/2 inch.
The attached photo shows more dimensions of this jack for you to review.
expert reply by:
Jared P
0
click to enlarge
Product Page this Question was Asked From
Round, Pipe Mount Swivel Jack w/ Footplate - Weld On - Zinc - Topwind - 10-3/4" Travel - 2K
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Swivel Jack
- Topwind Jack
- 11 Inch Lift
- Pipe Mount
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Is a Support Plate Needed When Installing Bulldog A-Frame Trailer Jack # BD1550101344
- Article: How to Charge a Dump Trailer Battery
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Q&A: Which Holds Up Better on Trailer Wheel Powder Coat or Acrylic Paint
- Q&A: Is 16 Gauge Wire Adequate for Trailer Wiring for Lighting
- Article: Trailer Lighting Requirements
- Article: Trailer Tire Sizing
- Q&A: How to Determine if Trailer has 84 Spindle to Pick Out Replacement
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Trailer Coupler for a Trailer with a Round Tube Straight Tongue
- Q&A: Can a 5.30-12 Size Tire be Replaced with a ST145/R12 Size Tire