Does the Redarc BCDC Battery Charger # 331-BCDC1225D Come With A Solar Input
Question:
Its confusion - you guys are showing two different photos for this item: one with the solar input and one without. Which is it?
asked by: Richard Y
0
Expert Reply:
The Redarc In-Vehicle BCDC Battery Charger # 331-BCDC1225D does come with an auxiliary input for connecting to a solar panel without the need for a regulator. I've attached a video to show you the installation and how this will be connected to the yellow wire for power input and then the solar panel will have it's own ground wire.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Redarc In-Vehicle BCDC Battery Charger - Dual Input - DC to DC - 12V/24V - 25 Amp
- Battery Charger
- Battery Charger
- RV/Camper
- Trailer
- 75 Ah
- 200 Ah
- Charges/Maintains
- 12V
- Solar Panels to Auxiliary Battery
- Vehicle Battery to Auxiliary Battery
- Redarc
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Redarc In-Vehicle BCDC Battery Charger - Dual Input - DC to DC - 12V/24V - 25 Amp
- Shop: Bulldog Winch Rear Wiring Kit - Quick Connect to Terminal End - 2 Gauge - 24' Long
- Shop: Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Q&A: Parts Needed to Charge a Trailer Battery for a Winch
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: How to Wire an Electric Winch
- Shop: Redarc Smart Start Load Disconnect for Manager30 or BCDC with Lithium Battery - 12 Volt - 100 Amp
- Shop: 60-Amp Relay Kit for Redarc In-Vehicle BCDC Battery Charger
- Q&A: Installation of Redarc BCDC1225D with Redarc RK1260- Blue Wire Location
- Q&A: Recommended Wiring Gauge for Redarc BCDC to Dual Battery Setup
- Shop: Redarc Smart Start Battery Isolator - 12 Volt - 100 Amp
- Shop: Trailer Hitch
- Search Results: 44649
- Q&A: How Much Slack Is Needed In Trailer Wire Connection To The Tow Vehicle?
- Shop: etrailer Electric Trailer Brakes - 12" - Left/Right Hand Assemblies - 5,200 lbs to 7,000 lbs
- Video: Stromberg Carlson RV Exterior Ladder with Hinges Installation - 2021 Keystone Passport SL Travel Tra
- Article: Trailer Wiring Diagrams
- Search Results: dust cap
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Shop: Trailer Wiring
- Q&A: Torque Specs for 3500-lb 5-on-4-1/2 Dexter Hub/Drum 84546UC3
- Video: Titan Trailer Brakes T2385200 Review
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Shop: Fifth Wheel Hitch
- Search Results: 68149
- Shop: Brake Controller
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Video: Solera Replacement Awning Fabric Measurement and Installation
- Search Results: 25580
Tom T.
5/11/2020
I think there is a LOT of confusion about these Redarc chargers that could be cleared up if someone (Redarc) would put together a comprehensive video. I am no electrical genius so I will not purport to have all the answers, But even with my limited experience & having read all the questions asked about these units, I feel there are some REAL BASIC answers that could be addressed if (someone) took the time to do it right. I'm not a YouTube video maker but I wish I was because when I watch & read some of the information and how it's presented I get a bit frustrated. I end up spending many hours to eventually learn something that (should have) been explainable in mere moments! PS: You don't need the EXPENSIVE Redarc fuse kit. These MIDI fuse holders can be found readily online from electric suppliers for less than 1/2 the cost!!