Wiring Harness for Connecting the Voyager Brake Controller on a 2008 Ford F-250 Super Duty
Question:
Took my 2008 F250 SD to get a gooseneck hitch installed , and the guy intalled a voager in the truck, all lights work but the controls box light does not come on . Im thinking is there a harness that I could buy to connect the box directly to the 14-way gray connector that the truck says it has? Also can the box go bad?
asked by: Joe M
Expert Reply:
The correct under dash harness for your 2008 Ford F-250 Super Duty, is the Tekonsha Wire Replacement for Ford Super Duty Pickups, item # 3034-P, if your controller has the Tekonsha connector attached to the wiring at the back of the controller. If your controller is a couple of years old you would need the Brake Controller Wiring Adapter for Pre-Wired 2008 - 2009 Ford Super Duty Vehicles, item # 3034-S, to hard wire to the wires at the back of the brake controller.
If your controller was working but is now not functioning properly there could be corrosion or moisture in the 7-Way connector that is causing the green light not to come on when the trailer is connected. This corrosion could be in the vehicle or trailer side connector. Also you should check for a loose power wire or ground wire that could be the cause for the light not coming on.
If this does not solve the issue you will need to sever the blue wire at the back of the brake controller. Leave enough room to reattach it once testing is complete. This will eliminate any possibility of trouble on the vehicle or trailer wiring. Then, using a circuit tester, item # PTW2993 if needed, test the black wire going into the brake controller for 12-volt constant power. Next, test the red wire for power, only when the brake pedal is pressed. If these functions are correct and there is no output on the blue wire when the Manual Slide Knob is activated there is most likely a problem inside the brake controller. Brake controllers have no user serviceable internal parts so you would need to replace the controller.
If replacement is needed, I would recommend the P3 brake controller, item # 90195, along with the # 3040-P wiring harness mentioned earlier.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Ford
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Product Page this Question was Asked From
Tekonsha Voyager Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Manual Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- Indicator Lights
- Up to 90 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Video: Trailer Wiring Harness Installation - 2008 Ford F-250 HM40975-11998
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Determining Trailer Tongue Weight
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Q&A: Wiring # 5504 Draw-Tite Activator IV Brake Controller On 2009 Ford F-250 and F-350
- Q&A: Brake Controller Port Location on a 2008 Ford F-250 Super Duty
- Q&A: Will Over-Rated Weight Distribution System Cause Harsher Ride
- Q&A: What Happens When A Weight Distribution System Is Over Adjusted
- Q&A: Does A Weight Distribution System Need To Be Readjusted If I Lift My Truck
- Q&A: Should Hitch Ball Angle Be Adjusted Up and Down or Angled to the Rear Using Weight Distribution
- Q&A: Adjusting Weight Distribution System to Apply More Weight to Front Axle of Tow Vehicle
- Shop: Tonneau Cover
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Video: Choosing the Right Trailer Wiring
- Search Results: 44649
- Shop: Trailer Hitch
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Article: Trailer Wiring Diagrams
- Shop: Trailer Wiring
- Search Results: 68149
- Article: How to Measure for Trailer Hitch Drop
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Search Results: 25580
- Shop: Suspension Enhancement
- Shop: Fifth Wheel Hitch
- Shop: etrailer Hitch Pin Alignment Collar for Hitch Accessories - 2" Hitches
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Search Results: 14125a
- Shop: Nylon Bushing - 9/16" Inner Diameter, 11/16" Outer Diameter - 1-3/4" Long
- Article: How to Choose the Right Trailer Hitch Class