Recommended Floor Mats for a Thor Motor Home Ford E450

Question

Question:

I have a class c four winds by thor motor home and would like floor mats to fit my ford E450

asked by: John B

0

Expert Reply:

We do have some floor mats that are made to fit a Ford E450, but just as a forewarning; since Thor designed the motor home, they could have made changes to the center console or other parts on the inside which could alter how a floor mate might fit. If Thor makes custom floor mats for your motor home, then I recommend getting those since they are made to fit your exact application.

We do have a wide variety selection of floor mats which are linked for your convenience. I recommend going with the WeatherTech Front Auto Floor Mats # WT26DV. These use retention hooks that help to keep the mats from moving around, and they also feature specially designed treads which help to channel fluids, dirt, and debris. Also, the high-density tri-extruded material that they are made out of gives them superior durability.

expert reply by: Jon G

0

Yves G.

6/12/2020

Looking for : 2019, E-450 Ford Écono Floor mat / carpet for Thor RV. Beige/ Tan intérieur : not two mats but one piece carpet.

Reply

Chris R.

6/16/2020

All of the mats/carpets we have available for your E-450 chassis are separate, two-piece sets like Covercraft # CC76335123. Unfortunately we don't have any larger one piece units.

Reply

Answer 1

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights…

view full answer...

Answer 2

If you are installing just the Firestone Ride-Rite kit, #F2400, and not also adding an on-board air compressor such as #F2158, then I would estimate that it should take about 2 hours to install the kit. That is for someone with some mechanical…

view full answer...

Answer 3

We do have the Rhino-Rack Masterkey Lock Barrels #RRRK093-2 which will provide you with 2 new lock cores and keys for your Rhino-Rack Zenith MasterFit Rooftop Cargo Box #RRRMFZ66. As far as pricing goes on the different sets they can change based…

view full answer...

Answer 4

Thank you for purchasing from etrailer! You did a great job selecting compatible parts. When using Leaf Springs #e64SR with the #AP233 Equalizer Kit and the #H248 Hanger Kit, there should be 29-1/2" between the front and center hangers and…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

The correct replacement for a Demco Master Cylinder 05680-C is the Replacement Master Cylinder part #5650. I spoke with Demco to confirm this for you.

view full answer...

Answer 8

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 9

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 10

The spacing will depend on the axle diameter and on which particular spring hanger kit you use. If you have a 6000 lb 3 inch diameter axle, and you're using the #APT5 hanger kit which includes 7-3/4 inch equalizers and 2-5/8 inch shackle straps…

view full answer...

Answer 11

I do have an option for you, but we do not carry the Dexter 072-027-00 you mentioned. However we do have the etrailer Double-Eye Spring for 7,000-lb Trailer Axles - 24-7/8" Long #e64SR which will be 3/8" shorter but that is still close…

view full answer...

Answer 12

Your trailer looks awesome! The Road armor equalizers #LC696740 and Equa-Flex Cushioned Equalizers #LC279687 are both pretty similar in performance even though the Road Armor has two dampers. The main difference is the size of the equalizers. The…

view full answer...

Recommended Floor Mats for a Thor Motor Home Ford E450

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching