What Circuits do the 2 Wires on a Trailer Surge Brake Actuator Wire To
Question:
I have a six 6 pin connector from my truck to my boat. The two wires coming off the surge brake... what wires do you connect them to on the 6 pin?
asked by: Darren
0
Expert Reply:
Your surge brake setup has an electric lockout solenoid. Either one of the wires on your brake needs to run to the reverse light circuit on your trailer connector and the other wire needs to ground. Doesn't matter which you use as they are not polarity sensitive.
On a 6-way the most likely pin to carry the reverse light circuit would be the center pin.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pollak 6-Pole, Round Pin, Plastic Trailer Wiring Socket w/ Rubber Boot - Vehicle End
- Trailer Wiring
- Trailer Connectors
- Vehicle End Connector
- Plug Only
- 6 Round
- Pollak
more information >
Continue Researching
- Q&A: Can the Curt Custom Tail Light Wiring Kit Be Used With LED Lights
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Q&A: Is There Tow Bar for 2024 Ford Bronco Everglades
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Will The Curt Dinghy Wire Harness # C96JR Interfere With Activation Of A Blue Ox Patriot
- Q&A: Does the Curt Custom Tail Light Wiring Kit for Towed Vehicles C96JR Fit the 2021 Jeep Wrangler 4xe?
- Q&A: Comparing etrailer and Blue Ox Baseplate Kits For A 2023 Jeep Gladiator
- Q&A: Parts Needed to Flat Tow 2023 Jeep Gladiator
- Q&A: Tow Bar Lighting Solution for 2023 Jeep Wrangler that Allows Charge for Battery
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Choose a High-Low Adapter