Door Hinge Pin For 1997 Sundowner 2 Horse Gooseneck Trailer
Question:
The shaft on the ramp of my trailer is bent making it impossible to lift the ramp once it is down. Do you sell the shafts and if not where do I buy one? Thanks in advance for your help
asked by: Cyndi
0
Expert Reply:
I have attached a link to the hinge pins we offer you can check out.
The hinge pins are either 1/2 inch or 3/4 inch diameter. We do not carry hinge pins that would be as long as the width of your trailer door.
expert reply by:
Jeffrey L
0
Product Page this Question was Asked From
1/2" Diameter Hinge Pin, 6-3/4" Long
- Trailer Door Hinges
- Hinge Pin
- Build Your Own Hinge
- 6-3/4 Inch Long
- 1/2 Inch Diameter
- Redline
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Brake Controller
- Shop: Replacement Black Door for 6-Gallon Atwood Water Heater
- Shop: Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Q&A: How To Install the Spindle Nut on a 12,000 Pound Dexter Axle
- Q&A: What is the Difference between Timbrens and SumoSprings for My 2022 Ram 1500 4x4?
- Q&A: Replacement for Dexter Mobile Home Axle Grease Seal 10-41
- Q&A: Can a Piano Style Hinge be Used on a Trailer Ramp Door that is 94 Inches Wide
- Q&A: Lug Nut Size Recommendation for 5,200 lb Trailer Axle
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Q&A: Mounting Hardware Needed To Install 3,500LB Axle & Double Eye Leaf Springs on a Torsion Axle Trailer
- Q&A: What Trailer Weight Requires Brakes