Wiring Diagram For Blue Ox 4-Wire Electrical Cord With Round Plugs

Question

Question:

I have the Blue Ox 4-Wire, Coiled Electrical Cord with 4-Way, Round Plugs. There are no markings on the plugs for wiring. Can you send me a diagram? Thanks,

asked by: Mike R

0

Expert Reply:

I have attached a photo of a typical 4-way round connector with the pins labeled you can check out.

The photo has both the trailer side and vehicle connectors labeled.

expert reply by: Jeffrey L

0

click to enlarge

Answer 1

According to Curt Manufacturing, their #C56407 trailer wiring harness is compatible with all models of the 2021 Jeep Wrangler Unlimited, so it'll work just fine for you. If you click the provided link, you can see an install video that you…

view full answer...

Answer 2

You'll only need a single fuse bypass switch like the Curt Fuse Bypass Switch for Towed Vehicles #C93HR you were looking at. You'll want to pull the ACC Radio fuse, which is fuse #34 and the location can be seen in the attached picture. To…

view full answer...

Answer 3

So what you could do is use the coiled tow bar wiring kit from Blue Ox part #BX8861 at the rear of the fifth wheel that has a 4-way flat connector as this comes with a 4-way round connector that can replace it as well as another one for the front of…

view full answer...

Answer 4

I went out to the warehouse and pulled a Blue Ox 4-Wire, Coiled Electrical Cord with 4-Way, Round Plugs, #BX8861, to take some measurements for you. When coiled up, from end to end it measures about 38 inches long. When stretched out to the maximum…

view full answer...

Answer 5

I have included a picture below that will tell you which wire goes where on a 4-Pin Round Vehicle Connector #PK11410. This will allow you to see what each pin is for the 4-Way Flat to Round Adapter #ADP001 that you already have.

view full answer...

Answer 6

It looks like you were checking out the Custer Trailer Connector Adapter - 4-Way Round to 4-Way Flat #ADP001 which does have the smaller ground pole and the 3 larger poles. This adapter will let you adapt a 4 way flat to fit a 4 pole round and will…

view full answer...

Answer 7

The Roadmaster Base Plate Kit part #1555-5 that you referenced has been confirmed to fit your 2005 Honda CR-V and comes with everything needed to attach to your Roadmaster Falcon 2 Tow Bar #RM-520. For safety cables you can use #RM-643. The coiled…

view full answer...

Answer 8

Yes, the Roadmaster Crossbar style base plate kit part #1555-5 is a confirmed for your 2006 Honda CR-V and the diode wiring kit part #RM-154 would also fit and work great too. The base plate kit is perfectly compatible with the Roadmaster Falcon 2…

view full answer...

Answer 9

We do carry the base plates for your 2006 Honda CRV that will work with the Roadmaster Sterling All-Terrain Non-Binding Towbar with 6 Wire Electrical, item #RM-576. Does your CRV have a brushguard or front bumper extra trim package?

view full answer...

Answer 10

Yes the Roadmaster InvisiBrake Supplemental Braking System Item #RM-8700 will connect directly to your towed vehicle's battery and charge it while driving unlike most braking systems that would actually drain your battery. Some notes to consider…

view full answer...

Answer 11

There are three types of hinges for replacement roof vents: 3 point, 4 point, and continuous. Replacement #BV0534-00 has a closed round hinge, which is continuous. It sounds like you need either a continuous hinge that is not closed such as…

view full answer...

Answer 12

Looks like you have a round 4-way connector in the picture you submitted. The colors you mentioned aren't totally a match for standard colors but they are close. Normally the colors are: White - Ground Return Green - Right Turn and Brake Lights…

view full answer...

Wiring Diagram For Blue Ox 4-Wire Electrical Cord With Round Plugs

Product Page this Question was Asked From

Continue Researching