Recommended Sliding Ladder Rack With Extension For 2016 Ford F-350 With 9-Ft Bed

Question

Question:

Looking for a sliding ladder rack with extension for my 2016 f350

asked by: Asdf

0

Expert Reply:

We have just the ladder rack you are looking for.

I recommend the TracRac SR Sliding Truck Bed Ladder Rack w/ Over-the-Cab Extension, part # TH43003XT-010EX. This ladder rack slides along th efull length of your truck bed and can be easily removed from the track when you are not hauling anything. It has an over-cab extension that can allow you to carry those longer loads like lumber or pipe. The load carrying capacity of the ladder rack is 1,250-lbs and the extension has a capacity of 1,000-lbs. The ladder rack has four heavy-duty load stops that helps keep cargo in place.

expert reply by: Jeffrey L

0

Answer 1

The base rails for the TracRac Sliding Truck Bed Ladder Rack, #TH43003XT-010, measure 97 inches long, 4-3/4 inches overall width, 2 inches overall height, 1-1/2 inches height at center, 1 inches wide rails at top and sides and 1-1/2 inches between…

view full answer...

Answer 2

Toolbox Mounting Kit #TH25200 can be used with any of the TracRac sliding ladder racks including #TH43003XT-510EX. For either style of the TracRac sliding ladder rack the front uprights mount to the outer tracks on the base rail. The inner track will…

view full answer...

Answer 3

Do you have a TracRac ladder rack installed currently with the overhead extension? Did you use the recommended parts for your truck or did you modify something else? I checked with Thule TracRac and they recommend the part number #TH43003XT-510EX for…

view full answer...

Answer 4

The base rails that are designed to fit the 2018 Fort F-150 (5-1/2 foot bed) - Ford Super Crew Trucks #TH21508 come with the Thule TracRac SR Sliding Truck Bed Ladder Rack - 1,250 lbs #TH43002XT-508. The Base Rails for Thule TracRac SR Sliding Truck…

view full answer...

Answer 5

When the Thule TracRac SR Sliding Truck Bed Ladder Rack w/ Cantilever - 1,250 lbs #TH43003XT-510EX is slid all the way forward in the unused position, it will take up about 16" of bed rail length. This is confirmed to fit your 2006 Ford F-250…

view full answer...

Answer 6

If your tonneau cover leaves the top surface of the bed sides free, we do have some ladder racks available that would work for you. The Thule TracRac SR, with cantilever #TH43003XT-010 or without #TH43003XT-010EX cantilever would be a great choice.…

view full answer...

Answer 7

The 7290 that you see is a casting number. It is found on AL-KO hubs that fit #99 spindles. I found that the bearings used are #28580 which would be the inner bearing and #25580 which would be the outer bearing. For the seal use #91030.

view full answer...

Answer 8

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 9

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Answer 10

Actually our etrailer.com brand brake assemblies are rebranded AxleTek assemblies. So we have the 8k left and right assembly set #AKEBRK-8 which is most likely what you need but these are 12-1/4 inch in diameter by 3-3/8 inches wide and attach with a…

view full answer...

Answer 11

I can definitely help you find the correct replacement hub and bearings for your Dexter P-12 SLR axle, but since part of the serial number was unreadable you will need to take a few simple steps to identify which bearings your axle uses. The easiest…

view full answer...

Answer 12

Because the Retrax PRO MX Tonneau Cover #RT80467 for the 2019 Chevy Silverado 2500 covers the bed rails, you would not be able to use a ladder rack like the Thule TracRac #TH27000XT since that rack requires the use of the bed rails. The only tonneau…

view full answer...

Recommended Sliding Ladder Rack With Extension For 2016 Ford F-350 With 9-Ft Bed

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching