Which Brake Switch Wire is Needed to Hardwire in a Brake Controller to a 2016 Toyota Tacoma
Question:
I have purchased the necessary parts to install a p3 controller on my Tacoma that has a flat battery direct plug installed. My question where do I tap into the brake signal in the cab and what is the wire color? Thank you
asked by: Steve H
0
Expert Reply:
On your 2016 Toyota Tacoma the brake switch wire you will need to hardwire in the brake controller red wire is going to be the blue wire at the brake switch. Use a circuit tester such as # PTW2993 or a meter if you have one to make sure that wire only has power when the brake pedal is pressed.
expert reply by:
Michael H
0
Products Referenced in This Question
Product Page this Question was Asked From
Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LED Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Replacement Hub for 2013 Wildwood 26TBSS Hub Drum with AL-KO 8700
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Q&A: How To Add a Fuel Tank To a Truck with 5th Wheel Hitch In Bed
- Q&A: Recommended 16' Mesh Tarp for Dump Trailer
- Q&A: How to Bleed Electric Over Hydraulic Trailer Brakes
- Q&A: What is the Estimated Installation Time for Firestone Ride-Rite Air Bags on a 2006 Ford F-250
- Q&A: Comparing the Curt Q20 and the Curt A20 5th Wheel Hitches.
- Article: Best Camper Jacks
- Article: How to Choose the Right Trailer Hitch Class
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)