Will Draw-Tite 76104 Fit A 2008 Jeep Wrangler Unlimited With A Factory Tow Hook
Question:
I just purchased a 2008 Jeep Wrangler X Unlimited. 4x4, 4 door. My Jeep has the factory tow hook welded to the back at the approximate center of the rear of the vehicle. Will part number 87424 work with this configuration. I have previously ordered 3 Draw-Tite brand hitches for my other vehicles and would like to stick with this brand for my Jeep if possible. Thanks
asked by: Frank
Expert Reply:
The Draw-Tite Class III 2 Inch Hitch # DT78MR will fit a 2008 Jeep Wrangler Unlimited without the factory tow hook. It will use the four factory holes on the rear crossmember. So the factory tow hook does have to be permanently removed for the hitch to be installed on your vehicle.
All of the hitches I have that fit your vehicle will install the same way, so to put a hitch on your 2008 Jeep Wrangler Unlimited you will have to remove the factory tow hook.
I am sending a link to the installation instructions for the Draw-Tite # DT78MR. You can also look at the linked installation video.
Product Page this Question was Asked From
Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- Custom Fit Hitch
- Class III
- 675 lbs TW
- 4500 lbs GTW
- 4500 lbs WD GTW
- 2 Inch Hitch
- 675 lbs WD TW
- No Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Best Bike Rack Out of Thule Epos, Hollywood Racks Destination, and Yakima OnRamp Bike Racks
- Article: How to Choose a Bike Rack for a Jeep Wrangler
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Can I Use The Draw-Tite DT78MR To Replace The Factory Hitch On A 2023 Jeep Wrangler 4XE
- Q&A: Supplemental Braking System for 2018 Jeep Wrangler JL with Spartan K2 Chassis with Safe Haul Air
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: Trailer Wiring Diagrams
- Q&A: Recommended Trailer Hitch for a Grand Design Solitude
- Q&A: What are the Dimensions of the Draw-Tite Max-Frame Trailer Hitch Receiver # DT78MR
- Article: Best Bike Racks for Electric Bikes
- Article: How to Choose a Bike Rack That Will Clear a Rear Mounted Spare Tire or Bumper