Can the Flexco Manual Pull-Out Step SMFP-1120 Attach Using Sides of Mounting Bracket
Question:
cant weld these to my livin lite camper. it is aluminium. original was mounted using side holes . using a square headed aluminium bolt. original was made by hickory springs . are you sure the side holes cant be used . what is the spacing of the square side holes? thanks
asked by: Bruce I
Helpful Expert Reply:
If the brackets on your camper match up to the side holes of the # SMFP-1120 it would work just fine to use them. Nearly all RV steps like this attach with the side holes and not the holes on top.
If the install brackets on your trailer are right at 21 inches apart this step would fit perfectly as that is the outside overall diameter of the steps.
Product Page this Question was Asked From
Flexco Manual Pull-Out Step for RVs - Single - 7" Drop/Rise - 20" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 20 Inch Wide Step
- 21-1/6 Inch Wide
- 1 Step
- 7-1/2 Inch Drop/Rise
- No Ground Contact
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Q&A: Gooseneck Trailer Hitch for a 1996 Ford F-450
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Recommended B&W Turnover Ball System for a 2023 Ford F-350 w/out the Prep Package
- Q&A: Depth of Flexco Manual Pull-Out Step Single SMFP-1120
- Q&A: How to Measure to Determine the Correct Grease Seal for a Trailer Spindle
- Q&A: Replacing Water Heater Element on Atwood GC10A-4E Water Heater
- Q&A: How Much Play Between Demco eZ Latch Trailer Coupler and 2-5/16 Inch Trailer Ball
- Q&A: Installing a 7-Way Connector on a 2020 Subaru Outback Wagon for Towing a Trailer
- Article: How to Raise Your Travel Trailer Height
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: How to Bleed Your Trailer Surge Brakes