Would Using Ball Mount Bike Rack on Weight Distribution System Require Adjusting Spring Bar Tension
Question:
I have a weigh distribution, for safety. can I place the c18013. also should I re adjust the wd to the new weight of the bike. suggestion. The tow vehicle is a ram 1500 same as the video.
asked by: Nery P
1
Helpful Expert Reply:
If you were to use the Curt Clamp-On 3 Bike Rack # C18013 on the shank of a weight distribution system you would need to consider the weight of the bikes and rack as tongue weight. This would mean that you would need to adjust the weight distribution system.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Curt Clamp-On Bike Rack for 3 Bikes - 2" Ball Mounts
- Hitch Bike Racks
- Hanging Rack
- Towing Rack
- Frame Mount
- Locks Not Included
- 3 Bikes
- Class 3
- Fits 2 Inch Hitch
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: Best Bike Racks for Electric Bikes
- Q&A: Will the EcoHitch Front Hitch 306-X7904 Fit the 2023 Ford F-350 w/ a Diesel Engine?
- Q&A: What Front Hitch Will Fit The 2023 Ford F-350 Dually?
- Article: How to Choose the Right Trailer Hitch Class
- Article: Carrying Bikes While Towing a Pop-Up Camper Trailer
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Article: My Trailer Hitch Doesn't Fit
- Q&A: How do I use a Bike Rack and Pull a Trailer at the same time
- Q&A: Difference Between Trailer Tire Sizes ST205/75R15 and ST225/75R15
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Will A Hellwig Sway Bar Fit A 2023 Ford F-350 With A TorkLift SuperHitch Installed
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Q&A: Recommended Tow Bar Wiring Harness & Flat Tow Setup For A 2021 Jeep Wrangler