Installing a Load Stop at Rear of 4 x 8 Foot Trailer
Question:
I loaded lumber on my trailer and there was no stop on the end of the trailer to keep the lumber from sliding out the end. A flat e track on the end of bed would work if I could slide a 2 x 4 on the end. Is there such a thing? There are no sides it is all flat.
asked by: Glen K
Helpful Expert Reply:
I have a solution that should work pretty well for you. I'd run a strip of E-track like # E19148 along the edges of the trailer, at least at the front and rear of the trailer.
The E-track could be used to secure the lumber using a ratchet strap like # SLLS28RER. The straps are sold individually, so you'd want at least two. At the end of the E-Track, you could use a wood beam socket like # 59149 to secure a board like you have shown in the photo. The sockets are sold individually.
Products Referenced in This Question
E Track Wood Beam Socket for Standard 2" Lumber - Qty 1
- E-Track
- E-Track Cargo Organizers
- Board Holder
- Erickson
more information >
Erickson Horizontal E Track - Zinc Plated Steel - 2,000 lbs - 5' Long - Qty 1
- E-Track
- E-Track Rails
- Horizontal
- 5-1/8 Inch Wide
- 2000 lbs
- 5 Feet Long
- Erickson
more information >
Snap-Loc E Track Tie-Down Strap w/ Ratchet and Soft Tie-Loop - 2" x 8' - 1,467 lbs
- Ratchet Straps
- Trailer
- 1 Strap
- Manual
- 6 - 10 Feet Long
- 1-1/8 - 2 Inch Wide
- 1201 - 1500 lbs
- Snap-Loc
more information >
Product Page this Question was Asked From
E Track Wood Beam Socket for Standard 2" Lumber - Qty 1
- E-Track
- E-Track Cargo Organizers
- Board Holder
- Erickson
more information >
Continue Researching
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Video: etrailer Class III Trailer Hitch Installation - 2023 Toyota RAV4
- Shop: Snap-Loc E Track Tie-Down Strap w/ Ratchet and Soft Tie-Loop - 2" x 8' - 1,467 lbs
- Shop: Bulldog Winch 17-Piece Deluxe Ratcheting Vehicle Tie-Down Strap Set - 3,335 lbs
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Search Results: 44649
- Video: Choosing the Right Trailer Wiring
- Shop: Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Shop: Grease Seals 10-36 (pair)
- Search Results: 68149
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Search Results: 25580
- Article: How to Choose the Right Trailer Hitch Class
- Video: Choosing the Right Brake Controller
- Shop: Brake Controller
- Q&A: Can Hydraulic Brakes of Demco Tow Dolly be Converted to Electric Brakes
- Shop: Dust Cap for Kodiak Disc Brake Kit
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Search Results: dust caps
- Shop: Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Video: Lippert Solera Slider Slide-Topper Review
- Shop: Fifth Wheel Hitch
- Article: Trailer Tire Sizing
- Video: etrailer Class III Trailer Hitch Installation - 2016 Jeep Cherokee
- Shop: Gooseneck Hitch