What is the Usable Length of the etrailer Pull Pin for Swivel Jacks
Question:
What is the usable length of the pin, length from ring to ball?
asked by: Rondell N
1
Helpful Expert Reply:
The usable length of the etrailer Pull Pin # TJP-PN916 is 3-1/2" with 3-1/8" to the center of the detent ball, as show in the attached photo.
This pin is designed for use with etrailer and Ram Pipe Mount Swivel Jacks 9/16" Diameter.
expert reply by:
Sarah H
1
click to enlarge
Product Page this Question was Asked From
Replacement Pull Pin for etrailer and Ram Pipe Mount Swivel Jacks - 9/16" Diameter
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Pins and Clips
- 9/16 Inch Pull Pin
- etrailer
more information >
Continue Researching
- Shop: Gooseneck Hitch
- Shop: B&W Companion Gooseneck-to-5th-Wheel Trailer Hitch Adapter - Dual Jaw - 20,000 lbs
- Search Results: 25" shank
- Shop: Kenda Karrier ST235/80R16 Radial Trailer Tire with 16" Black Mod Wheel - 6 on 5-1/2 - LR E
- Shop: Trailer Light Mounting Bracket for 6-1/2" Oval Trailer Lights, Steel - Black Powder Coat
- Shop: Dexter Trailer Hub Drum Assembly - 9K to 10K - 8 on 6.5 - Oil Bath - Non-ABS Drum - After July 2009
- Shop: Replacement Trailer Hub Bearing - LM48548
- Search Results: hitch
- Search Results: lm48548
- Search Results: replacement cargo trailer door
- Search Results: cargo trailer door
- Search Results: bearing kit
- Search Results: 10k bearing kit
- Shop: Trailer Wiring
- Shop: B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Shop: Curt Custom Wiring Adapter for Trailer Brake Controllers - Dual Plug In
- Shop: Fifth Wheel Hitch
- Q&A: Usable Length of Available 9/16-Inch Diameter Pull Pins
- Q&A: Bearings For Older Trailer Hub 22834
- Q&A: Troubleshooting Power Draw of Dexter EOH Actuator on Trailer Auxiliary Battery
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Does Weld-On Barrel Hinge MA29ZR Have Weight Capacity? Thanks
- Q&A: Replacement Trailer Hubs Using L68149 and L44649 Bearings
- Q&A: Is it a Good Idea to Replace Hub/Drum When Replacing Brake Assembly on Trailer
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Q&A: Typical Trailer Lug Nut Diameter and Thread Pitch
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Measure a Trailer Axle
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps