How to Wire the Battery Isolation Solenoid # PK5231201
Question:
Is it correct to assume the two connection on the sides are for the 12V power supply and the connection of the front is for ground?
asked by: Tye S
Expert Reply:
I spoke with my contact regarding how to wire the Battery Isolation Solenoid, # PK5231201. He stated that, if you are looking at the unit with the dome facing up and the 12v sticker right side up (like we have it shown in the picture on the product page), the left terminal is input, the right terminal is output, and the middle is auxiliary which will be connected to a source that will act as a switch to engage/disengage the solenoid. He stated that normally, the middle terminal is attached to an ignition switch wire.
Product Page this Question was Asked From
Starter Solenoid - SPST - 12 Volt - 100 Amp - Continuous Duty - Grounded
- Accessories and Parts
- Battery Boxes
- Switches and Solenoids
- 100 Amp
- Pollak
more information >
Continue Researching
- Shop: Curt Rebellion XD Shock Absorbing Adjustable Ball Mount w/ 2" and 2-5/16" Balls - 20K
- Q&A: Adding a Battery on an Enclosed Trailer to Power Interior Lights
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Video: Redarc Battery Chargers - Battery Isolators - 331-SBI12KIT Review
- Video: Ultra-Fab Phoenix Electric Remote Trailer Jack Review
- Shop: Heavy-Duty M8/M10 to SAE Adapter for OptiMate Battery Chargers and Cables
- Shop: Jensen Antenna - Top or Side Mount - Rubber Mast
- Q&A: What Does Yellow Wire of 7-Way Molded Trailer Wire Connector H20044 Wire To
- Shop: Bulldog Powered Drive Trailer Jack - Drop Leg - A-Frame - 22" Lift - 4,000 lbs - White
- Shop: Replacement Breakaway Switch for Bright Way Trailer Breakaway Kits
- Shop: Redarc Smart Start Battery Isolator with Wiring Kit - 12 Volt - 100 Amp
- Shop: Curt Rebellion XD Shock Absorbing Adjustable Ball Mount w/ 2" and 2-5/16" Balls - 15K
- Shop: RV Antenna and Radio
- Q&A: Recommended Battery Isolator for Diesel Truck Start and Nearly Dead Trailer Batteries
- Q&A: Can Lights, Jack, and Winch be Powered by 12V Circuit Coming From Tow Vehicle
- Q&A: Where Does Battery Isolation Solenoid Install and Can Vehicle Alternator Overcharge RV Batteries
- Q&A: How to Charge a Trailer Battery Through a 7-Way Connector
- Q&A: Installing a Battery on a Trailer and Wiring it to Run Interior Trailer Lights
- Search Results: 6 pin connector trailer
- Search Results: 12v diode
- Video: Review of Curt Trailer Hitch Ball Mount - Adjustable Ball Mount - C57UR