Tire Pressure Rating for Pontoon Boat Trailer Tires

Question

Question:

On my platoon boat I have 20.5x8-10 tires on it what is a good tire pressure for it I always blow a tire out.??

asked by: Phil

0

Expert Reply:

Trailer tires typically blow out if they are not properly inflated. Trailer tires need to have the max tire pressure listed on the sidewall in them at all times otherwise they can fail due to reduced capacity and heat build up.

Be sure you are not exceeding the speed rating for the tire or overloading it as well.

expert reply by: Jameson C

0

Answer 1

The 205/65-10 trailer tire size comes in different load ranges and each load range has a different psi requirement. A load range B in this size should be inflated to 35 psi. Load range C inflate to 50 psi. For load range D inflate to 70 psi. And…

view full answer...

Answer 2

The correct air pressure for your Kenda Loadstar 205/65-10 tires will be dependent on the load rating of your tires, and you will want to make sure they are aired up to the maximum PSI of the tire which will be stamped on the sidewall. Also go…

view full answer...

Answer 3

Special trailer tires should be inflated to their maximum air pressure. At the maximum air pressure, the tires will perform and wear best, and get the best gas mileage. The Kenda 205/65-10 Bias Trailer Tire #AM3H430 has a maximum load carrying…

view full answer...

Answer 4

The tires in your size that we offer have varying pressure ratings depending on their load capacity. For example, if you look at the tires in your size shown on the link I have included you will see that those rated for Load range E, such as…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

view full answer...

Answer 7

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 8

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 9

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 10

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 11

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Answer 12

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Tire Pressure Rating for Pontoon Boat Trailer Tires

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching