Holes Drilled and Attachment Point for Installing Draw-Tite Receiver Part # 24831 on Infiniti G37
Question:
Will we need to drill holes in the car to affix the hitch to the car Infiniti G37? Is it a direct fit to the frame? Thanks
asked by: Chuck
0
Expert Reply:
Two 3/4 inch holes will need to be drilled in the bumper cover to access the bolts in the fascia support. These holes will be hidden by the license plate.
The hitch bolts to the aluminum bumper, not the frame. The lower bumper fascia will need to be trimmed to allow the receiver to pass through it as well. This is explained in the installation instructions that I have linked to below.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Draw-Tite Sportframe Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class I
- 200 lbs TW
- 2000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Size Wrench is Needed for a 2" Hitch Ball with 1 Inch Diameter Shank
- Article: Flat Towing Package for 2012-2014 Honda CR-V
- Article: Best Vehicles to Flat Tow Behind an RV
- Q&A: Recommended 2010 Infiniti G37S Convertible/Manual Flat Tow System
- Q&A: Trimming/Removing Bumper Cover to Install Curt Class I Receiver Part # C11068 on 2009 Infiniti G37
- Q&A: Recommended Towing Package For A 1997 Suzuki Sidekick Sport
- Q&A: Parts Needed to Flat Tow a 2005 Honda CR-V
- Q&A: Can a 2019 Toyota Rav4 Be Flat-Towed