What is the Mounting Hole Width on Demco 21K Trailer Coupler DM15791-97

Question

Question:

looking for the width if mounting holes inside width of required mounting channel for DM15791-97

asked by: Trevor C

0

Expert Reply:

Demco coupler # DM15791-97 is designed to fit a 3 inch wide channel bracket such as # DM59602. On the coupler where it mounts to the channel the distance from the outside of one flange to the other is approximately 2-7/8 inches. I have included a picture illustrating these dimensions for you.

The holes on both are space 2 inches apart on center (vertically) and are 5/8 inches in diameter.

expert reply by: Michael H

0

click to enlarge

Answer 1

The Flint Hill Goods Square LED Brake Light Hitch Cover for 2" Hitches #FHG72VR would indeed be compatible with the #118384 on your 2012 Chevy Colorado. Using the turn signals will not cause the hitch cover to blink. The cover will light when…

view full answer...

Answer 2

Instead of using the Hydraulic Brake Kit #AKFBBRK-35-D which requires using 14"-16" wheels you should use the Dexter Galphorite Free-Backing Hydraulic Trailer Brake Assembly Right #T4423400 and Left #T4423500. These will fit with your…

view full answer...

Answer 3

The best way to identify the seal needed, is to get the number that is stamped or imprinted on the seal. You may have to remove the seal in order to see the numbers. If you cannot find the number on the seal, if you can find the numbers on the inner…

view full answer...

Answer 4

Based on the information I could find for the DICO 45264 is was popular on ShoreLand'r trailers. This would require the Idler Hub #AKIHUB-545-35-G-EZ-K with the Grease Seal #168255TB used instead of the seal included with the hub. We currently do…

view full answer...

Answer 5

The Dexter 8-427 hub is no longer available. Even looking through Dexter's site the only references to it are replacement bearings. You can use a wheel with a larger pilot hole as long as the wheel attaches to the hub using lug nuts and not…

view full answer...

Answer 6

We do have the correct bearing kit, along with the spindle washer and nut for your Lippert 5,200 lb axles. What you need are the following: - Bearing Kit #BK3-300 - Trailer Spindle Nut #165686 & Washer #SW1000

view full answer...

Answer 7

I did some research and found that the 12194TC seal you said you have measures 1.250 inside diameter, and 1.979 outside diameter. The seal I recommend is part #34823. The dimensions listed for this seal are 1.249 inside diameter and 1.983 outside…

view full answer...

Answer 8

We do have a very similar replacement coupler that is rated for 21,000 GVWR, and it is the Titan Bolt-On Coupler #T4855300. The angle that your photo was taken I can not tell if it is a 2 or 3 hole adjustable coupler, but this Titan part is a 3 hole…

view full answer...

Answer 9

I do have an option for you but there is not a version of the Titan Zinc-Plated A-Frame Brake Actuator for trailers with disc brakes. The only a-frame trailer coupler we do offer for use with disc brakes is the Demco Hydraulic Brake Actuator w/…

view full answer...

What is the Mounting Hole Width on Demco 21K Trailer Coupler DM15791-97

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching