Trailer Hitch Recommendation for a 2007 Wild Travel Trailer with 4 inch Welded Rear Bumper
Question:
I have a 2007 wild Travel Trailer, like most it has a 4 box bumper on the rear, unlike most its a little stiffer but not what I feel comfortable towing with. I like this setup better than having something custom made but my question become about the attachment point. I have an I beam on the frame that end a full 6inch shorter than the rear of the RV, to this 4x2 tubing was welded and then the 4inch box tube welded to that. Even if I could attached to the ibeam, which I cant because of the jacks and everything else it would put the receiver well under the RV, So now I am pretty much stuck attaching to the 4x2 tubing, my concern is will this support the receiver?
asked by: John
Expert Reply:
I can't recommend you use the bumper brace tubing for attachment of the Curt Hitch part # 13703 that you referenced but I do have a hitch solution that I can provide.
Since you have a 4 inch continuously welded rear bumper the best solution for installing a trailer hitch is going to be the Curt part # E-100 instead.
Products Referenced in This Question
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Product Page this Question was Asked From
Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide
- RV and Camper Hitch
- Frame Mount Hitch
- 22 - 72 Inch Wide Frame
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Weld-On
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Will the Draw-Tite Trailer Hitch Fit a 2022 Volvo XC90 Recharge
- Article: Trailer Wiring Diagrams
- Q&A: Typical Trailer Suspension Hanger Spacing Relative to Leaf Spring Size
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Q&A: How To Connect A Dometic 310 RV Toilet To A Supply Line That's Too Far Away
- Q&A: Best Upgrade for Dometic 310 Part-Timer RV Toilet
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: Replacement Hub Needed for Lippert 122093 Hub on 5,200 lbs Axle
- Q&A: How To Activate 12V Trailer Charge Circuit On 2019 Ford Super Duty With Factory 7-Way
- Q&A: Replacement Lift Motor for Fantastic Vent in 2002 Teton 5th-Wheel Trailer
- Article: 2023 Best Gifts for Outdoor Enthusiasts
- Article: How Harvest Hosts Is Becoming the New Standard of the Camping Industry
- Article: How to Replace or Install an RV Roof Vent