How to Remove and Reinstall the Retaining Clips on a Curt Round Bar Weight Distribution System
Question:
How do you remove and reinstall the retaining clips on a curt distribution hitch
asked by: Ron M
0
Expert Reply:
To remove the retaining clips # 17109 on a Curt weight distribution system with round bars you would first remove the bottom screws holding them on. Then you would push the clips up so the wider part of the hole can slip off the top pin.
The top pin fits into the groove in the spring bar when inserted into the head. If the pins are also being replaced pull out the old ones and then insert the new ones.
To install the clips you would reverse the above process.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Curt Spring Bar Retainer Package for Round Bar Style Weight Distribution
- Accessories and Parts
- Weight Distribution Hitch
- Hardware
- Rivets
- Spring Bar
- CURT
more information >
Continue Researching
- Q&A: Removing and Replacing Spring Bar Retaining Clips of Curt Weight Distribution System
- Q&A: Flow Max RV Fresh Water Pump Shutoff Test Pressure
- Q&A: Disc Brake Kit Availability for a Dexter 10k Axle
- Q&A: Replacement Trailer Brake Assembly for B12EA-22 on 2018 Forest River 294BH Travel Trailer
- Article: 2023 Best Gifts for Haulers & Towers
- Q&A: Replacement Hubs, Wheels, and Tires for a Boat Trailer That Uses Dico 45263 Hubs
- Article: Which Hitches are Made in the USA
- Q&A: How to Install a Brake Controller on a 2017 Chevrolet Silverado 1500
- Q&A: What Size Trailer Frame Will the Replacement Weight Distribution Chain Hangers Fit On
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide
- Article: Gooseneck to 5th Wheel Adapters
- Article: How to Measure a Trailer Axle
- Article: Trailer Wiring Diagrams
- Article: 5 Things to Know About Weight Distribution Hitches