What Gooseneck Hitches Work With Curt X5 5th Wheel Base Rails Adapter  

Sounds like you may not have a B and W gooseneck hitch since that brand uses square holes. Could you possibly check under the truck bed to see if you can see a brand? With more info I could see if we have a suitable adapter.

The shaft that fits in the gooseneck hitch on the Curt X5 adapter, #16310, is centered between the two 5th wheel rails. If you were to measure from the center of that shaft to the rear edge of the back rail or to the front edge of the front rail it…

The bed rails used on the Curt X5 Fifth Wheel Adapter are indeed compatible with Reese standard and sliding hitches. This particular adapter is only compatible with B&W Turnover Ball Gooseneck Hitches using a square shank. I have linked you to…

The Curt X5 5th Wheel Base Rails Adapter for B&W Turnoverball Gooseneck Trailer Hitches - 20,000 lbs #16310 has a measurement of 14 inches from the front rail edge to the center of the gooseneck. I went to our warehouse to measure it for you.…

Yes, the Curt X5 Fifth Wheel Adapter for B&W Square Shank Turnover, will allow you to use your Reese 15K Fifth Wheel hitch. The Curt Adapter works with Curt 16K and 20K hitches as well as Reese Fifth Wheels up to 20k among other manufacturers.

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

It sounds like you are talking about moving your leaf springs down further on the hangers installed on the frame of your trailer. If that is the case then as long as each end of the spring is moved down the exact same distance, you will get the much…

Yes it does! The B&W Companion 5th Wheel Hitch #BWRVK3600 that fits your 2018 Ram 2500 with the factory puck system is completely compatible with a MORryde cushioned pin box. This is a fantastic set up, giving you a cushioned pin box along with…

You can definitely use a cushioned pin box with the B&W Companion 5th Wheel Trailer Hitch #BWRVK3400-5W like a Mor-Ryde, Trailair, or 5th Airborne. For more info on 5th airbornes and for a review video of the hitch check out the links I attached…

When installing the pivot arms on your B&W Companion #BWRVK3400-5W you'll need to measure from the ground to the floor of your bed and from the ground to the plate of the pin box on the trailer down to the ground while it's level. The…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…