Is There A Weight Capacity Rating For Strap Hinge For Enclosed Cargo Trailer Doors

Question

Question:

Can you tell me what the weight rating is for these hinges? I am building a sound booth and the door will likely be 50 lbs. thanks Paul

asked by: Paul

0

Expert Reply:

The Strap Hinge for Trailer Doors, part # 2512 do not have a weight rating listed.

These are made of heavy-duty 8 gauge zinc-plated steel and measure 12-inches long. For a heavier door you may want to use an additional hinge to make sure they can handle the weight.

expert reply by: Jeffrey L

0

Answer 1

What you're planning sounds like it would work, but you'll need to be sure you have some cross members in the door where each hinge mounts. Since the doors are large and are likely pretty heavy, I'd use the biggest hinges you can. If you…

view full answer...

Answer 2

I have reached out to my contact at Polar before asking about the weight rating of their straps, like part #2512, and I have been told that they don't really have a weight rating. There are so many different variables into the equation that it is…

view full answer...

Answer 3

You will have to determine where the sag is coming from. Are the hinges worn out? If so, you would need to replace them. We have strap hinges like the part #2512 which are commonly what is found on barn style trailer doors.

view full answer...

Answer 4

Seal 171255UC has an inner diameter of 1.719 inches and outer diameter of 2.565 inches. A seal that has those dimensions would actually be #58846. I've added a link to a video review of this seal for you to take a look at.

view full answer...

Answer 5

Since the issue appears to be on the vehicle side for your 2017 Toyota Tacoma, I recommend first checking the connector itself. Look to see if there is any dirt or corrosion built up inside the connector that may preventing a solid connection with…

view full answer...

Answer 6

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 7

I would love to help you upgrade the suspension on your Twilight 2800 travel trailer. The MORryde Rubber Equalizers for Tandem Axle Trailers #MR87ZR that you referenced are a great solution but we do need to double check a few things. First is that…

view full answer...

Answer 8

Below is the general process for bleeding an electric over hydraulic brake actuator like #K71-650. Fill reservoir with NEW brake fluid. Never re-use brake fluid that has been salvaged or removed from another system. Remove the key from the breakaway…

view full answer...

Answer 9

Unfortunately there are no plug-in adapters or harnesses that would allow you to replace the factory 4-way flat trailer connector with a 7-way or a 7-way and 4-way connector on your 2005 Ford F-150. To complete the installation for a brake controller…

view full answer...

Answer 10

To tow your trailer that uses an RV style 7-way blade style connector with your semi that has a 7-pin connector, you need to construct an adapter that will also combine the brake signal into the right and left directional signal pins. This can be…

view full answer...

Answer 11

Normal operating temperatures for drum brakes range from 150-400 degrees F. During certain stopping conditions the brake heat can exceed 600 degrees. The effectiveness and stopping power of the brakes is significantly reduced at these higher…

view full answer...

Answer 12

The Tow Ready wiring harness #118571 is rated for 7.5 amps for brake lights and turn signals and 7.5 amps total for running lights. The fuse that goes on the power wire connection to the battery is a 10 amp fuse. The wire gauge of the long 12 volt…

view full answer...

Is There A Weight Capacity Rating For Strap Hinge For Enclosed Cargo Trailer Doors

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching