Does the Gorilla-Lift Come in Other Color Options

Question

Question:

Are there color options on the gorilla-lift besides yellow ?

asked by: Bryan

0

Expert Reply:

While the Gorilla-Lift Utility Trailer Tailgate Lift # GL1 that you referenced is only available in yellow, it is possible to the paint the outer housing of the tailgate lift. I spoke with my contact at Gorilla-Lift and she confirmed that the housing can be painted.

This can be done before installation, while the tailgate lift is still disassembled. Painting before installation will help protect the lift's inner components from the paint.

expert reply by: Victoria B

0

Answer 1

I attached a page from the install instructions for your Gorilla Lift Tailgate Assist #GL1 that covers how to lower the spring tension.

view full answer...

Answer 2

Since your gate is under 300 lbs I recommend using the Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable #GL1. This is rated for 300 lbs and is compatible with open utility trailers that have square-tube, round-tube, or angle-iron side…

view full answer...

Answer 3

I spoke with my contact at Fulton and he stated that what you are describing is a symptom of the jack screw inside the jack seizing up. You have a couple of options. First, you can try to take the jack apart and free the screw. If you cannot, the…

view full answer...

Answer 4

Each assembly that goes on one side of the trailer is actually two pieces, which gives you easy access to the mounting holes located on the underside of the assembly. You will need to drill holes in the tops of the trailer sides to attach the…

view full answer...

Answer 5

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 6

For all intents and purposes, yes, the Fulton drop leg stabilizer jack SJL80300 is the same as the square leg jack you asked about: - Square Drop Leg Stabilizer Jack - 18" Travel - 2,000 lbs #SJ-R208 Different manufacturers but otherwise they…

view full answer...

Answer 7

If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…

view full answer...

Answer 8

That is an excellent question and is asked more often than you think. Electric brakes like what come in the Electric Trailer Brake Kit #AKEBRK-2 can be submerged in water when you are loading/unloading your boat. Since water and electricity don't…

view full answer...

Answer 9

Since the discontinued MaxxAir 4700k model fits a standard 14 x 14 RV vent opening, I recommend the MaxxFan Plus Roof Vent w/ 12V Fan - 10 Speed #MA00-04500K. The MaxxFan Plus comes with a thermostat and a remote for easy temperature customization.…

view full answer...

Answer 10

For your enclosed trailer application I have several suggestions for adding interior lighting that you can control directly via a switch. Since your current 4-pole trailer wiring does NOT include a 12V auxiliary power feed that could power inside…

view full answer...

Answer 11

The only way you could power interior dome lights on a trailer without it being connected to a tow vehicle would be to power the lights with a battery like a breakaway battery. How you choose to wire up the batteries will in the end be up to you, but…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Does the Gorilla-Lift Come in Other Color Options

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching