Diameter of Hole the Wheel Masters and Namsco Wheel Covers Snap Into
Question:
What is the diameter of the hole in the hubcap that this will snap into? Lug Nut Covers for Wheel Masters and Namsco Wheel Covers - Chromed ABS Plastic - Snap In - Qty 4 Wheel Masters Wheel Accessories Code: WM9003-4
asked by: Mike
0
Expert Reply:
I was able to go out to the warehouse and measure the diameter of the hole on the # WM9003-4 for the hubcap that these will snap into and got 1.327 or about 1-1/8 inches. I also measured the nut impression size and got 1.037 or about 1-1/32 inches.
expert reply by:
Jackie C
0
Product Page this Question was Asked From
Lug Nut Covers for Wheel Masters and Namsco Wheel Covers - Chromed ABS Plastic - Snap In - Qty 4
- Wheel Covers Hubcaps
- Lug Nut Covers
- 4 Lugs
- ABS Plastic
- Wheel Masters
more information >
Continue Researching
- Shop: Snap-In Plug for Lionshead Trailer Wheel Center Caps - Chrome
- Q&A: Trailer Hub Bearing Protectors for a Jayco Fifth Wheel
- Q&A: Baby Moon Hubcaps For 16 Inch Wheels With 8 Lugs
- Article: Trailer Hitch Receiver Sizes
- Q&A: Will the Draw-Tite 3594 Get Me Close to 16 of Rise if My Hitch is 11 1/2 Off the Ground?
- Q&A: How Much Grease Should I Buy To Pack Wheel Bearings
- Article: Trailer Lighting Requirements
- Q&A: Replacement Tire and Wheel with Aluminum Wheels for a 1995 Jayco Pop-up Trailer
- Q&A: Replacement Motor for Slide Out Motor with Part # 8532-18HT
- Q&A: How to Select Battery Isolation Solenoid for 1985 Class C RV
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Stability Control for Heavy Duty Vehicles
- Article: How to Determine Tire/Wheel Diameter
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Measuring a Trailer Tire