Tips for Trailer Hitch that Won't Line Up Totally with Install Holes
Question:
I recently purchased a Draw-Tite Trailer Hitch Receiver Class II - 1-1/4 for my 2006 Lexus ES330. I have managed to get 4 of the 5 bolts in. But the opening for the 5th bolt the forward-most bolt on the driver side does not quite line up with the hole on the frame. It seems to be off by about 1/8 inch, and I cannot get the bolt in. Ive tried loosening the bolts already in, tightening them, shifting and adjusting the hitch every way possible - no luck. Have you seen this before? Do you have a solution? I have pictures I can send. Please help. Thanks,
asked by: James H
Expert Reply:
It is possible that the # 36336 hitch you have bent slightly in shipping. We see this happen occasionally and since that rear bracket is a separate piece from the bracket in front of it could have easily bent in or out.
What you can do is try bending the hitch back slightly to get the hole to line up. As long as there is no paint flaking or creases in the metal you would be fine.
Product Page this Question was Asked From
Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- Custom Fit Hitch
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Visible Cross Tube
- Draw-Tite
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Shop: Draw-Tite Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Video: Trailer Hitch Installation - 2005 Toyota Camry
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Is etrailer Tonneau Cover For 2022 Ram 1500 With 5-1/2 Foot Bed Sturdy & Easy to Remove
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Diameter of Replacement Hinge Pin # 362TRCHingePin2
- Q&A: 4 Lug Trailer Wheel and Tire with Higher Speed Rating
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Does Installing a Hitch on a 1999 Toyota Camry Involved Cutting Fascia or Bumper
- Q&A: Correct Replacement for TDE 46210 Trailer Hub
- Article: How to Choose a Cargo Carrier That Will Clear a Rear Mounted Spare Tire or Bumper
- Q&A: Replacement Curt Trailer Wiring To Replace Older s0601u-r1 Powered Converter
- Article: Trailer Hitch Installation Tips
- Article: How to Clean Weld Nuts for the Installation of a Trailer Hitch | etrailer.com
- Article: How to Measure for Trailer Hitch Drop