Compatibility of 5th Wheel Hitch with Tool Box/Transfer Tank in 2015 Ram 2500 Mega Cab 4X4
Question:
Trying to find out if I can put a fifth wheel hitch in my 2015 Ram Mega cab 2500 4x4. Ive already installed a fuel/toolbox combo that sticks out 22inch from the front of the bed. I need to find out if one of your sliding hitches like the Pro Slider 15k will still fit. The installer that put my tank in says it fit but Im skeptical at best. Thanks!
asked by: Shannon J
Expert Reply:
You can compare the installation instructions for a sliding 5th wheel hitch to determine if there will be enough space for it along with the tool box/transfer tank you have installed in your 2015 Ram Mega Cab 2500 with 6-foot bed and no factory rail kit.
With Curt base rail install kit # C16427-204 the position of the front-facing edge of the front base rail on a 6-foot bed will be 54-1/4-inches from the rear edge of the truck bed (not the tailgate) as shown in the linked diagram taken from the instructions. This dimension will allow you to check the fit with your tool box. An install video is linked for you too.
The slider hitch I suggest is the Curt 16K # C16521. This hitch includes important features like a fully-articulating head assembly for easier hitching on uneven ground and dual jaws for better king pin contact. Both of these will improve ride quality. And the hitch's 12-inches of slider travel gives you the turning clearance you need with a short bed.
For a wiring harness use part # C56000 which plugs right in at your bumper-mounted 7-way, no cutting or splicing required.
Products Referenced in This Question
Curt A16 5th Wheel Trailer Hitch w/ R16 Slider - Dual Jaw - 16,000 lbs
- Fifth Wheel Hitch
- Sliding Fifth Wheel
- Above Bed Rails
- 4000 lbs Vertical Load
- 16000 lbs GTW
- Cushioned Double Pivot
- Standard - Double Jaw
- 17-1/2 - 21-1/2 Inch Tall
- 12 Inch Fore/Aft Travel
- CURT
more information >
Curt 5th Wheel/Gooseneck Custom Wiring Harness w/ 7-Pole Connector - 10' Long
- Custom Fit Vehicle Wiring
- Fifth Wheel and Gooseneck Wiring
- 10 Feet Long
- Custom Fit
- 7 Round - Blade
- CURT
more information >
Product Page this Question was Asked From
Curt Custom Fifth Wheel Installation Kit for Ram Truck - Carbide Finish
- Fifth Wheel Installation Kit
- Custom
- Above the Bed
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement RV ladder for 2007 Monaco Diplomat
- Q&A: How to Determine the Right Air Pressure to Fill a Trailer Tire
- Q&A: What is Max Safe Tire Temperature
- Article: Rooftop Cargo Carriers
- Q&A: What Size Battery Is Needed for the Lippert 6-Point Ground Control
- Q&A: Could GO Power Solar Panel kit part # 34273836 Mount to Pin Box and Use SAE Port
- Article: RV and Camper Types, RV Classes
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: Size of Hole Saw to Use to Install the Recessed Trailer D-Ring Tie Down RR5K
- Article: Ram Trailer Tow Prep Package
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Gooseneck to 5th Wheel Adapters