Will UWS Replacement Toolbox Strut Fit a Husky Toolbox
Question:
Do these fit a Husky truck toolbox?
asked by: Tim L
0
Expert Reply:
the replacement strut # UWSLIFTCYLIND is designed for UWS toolboxes. To determine if it will fit on a Husky box you will need to take some measurements.
The strut fits on ball studs mounted in the toolbox that are 9.75mm in diameter. For a replacement ball use # UWSBALLSTUD. The strut measures 7 inches in length when fully retracted, and 11 inches long when fully extended.
expert reply by:
Michael H
0
click to enlarge
Products Referenced in This Question
UWS 10-mm Ball Stud for Toolbox Lift Strut (Qty 1)
- Accessories and Parts
- ATV-UTV Tool Box
- Trailer Tongue Box
- Trailer Tool Box
- Truck Tool Box
- Underbody Tool Box
- Lift Strut
- UWS
more information >
Product Page this Question was Asked From
Replacement Lift Cylinder for UWS Toolboxes
- Accessories and Parts
- ATV-UTV Tool Box
- Trailer Tongue Box
- Trailer Tool Box
- Truck Tool Box
- Underbody Tool Box
- Lift Strut
- UWS
more information >
Continue Researching
- Q&A: Replacement Dexstar Trailer Wheel with 17-231 Sticker
- Article: Replacement Automotive Lighting
- Q&A: Hub and Rotor Replacement Kit for ALKO 12k Axles
- Q&A: How Much Does Round Swivel Marine Jack w/Wheel Bolt On Zinc Sidewind 10" Travel 1,000lbs MJ-1206B
- Q&A: Swivel Jack Compatible With Malone MicroSport Trailer With 2 Inch Wide x 3 Inch High Tongue
- Article: What is Overlanding? How to Start your Overlanding Journey
- Q&A: What Tool Box Does Replacement Lift Cylinder # UWSLIFTCYLIND Fit
- Article: Trailer Wiring Diagrams
- Article: Testing Brake Controls
- Q&A: How to Remove Rotary Switch from Ventline Vanair Trailer Roof Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Compressor Not Working on 13,500 Btu Advent Air RV Air Conditioner