Troubleshooting Brake Controller that Only Shows Connection When Test Light is Connected
Question:
Hi I have a tekonsha voyger controller on my 4x4.I have power to the unit and when I apply the break pedal too so this is all good. The earth is all good as well . The led light will only come on when I put my test light from the neg Batt terminal to the blue wire ????? The override slider control makes the normal clicking noise when pressed. Not sure what my problem is ?? Can you help Thanks
asked by: Scott
Expert Reply:
Try hooking up a trailer to your 7-way. I would be surprised if the controller didn't work. You see, the controller has to detect a load on the output circuit (the brake magnets), in order for the controller to sense a trailer and start activating the brakes. Since your controller shows a connection when a test light is applied that shows that it's working.
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Trailer Running Lights Do Not Work but Brake Lights and Turn Signals Do Work
- Article: How to Troubleshoot Your RV Air Conditioner
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Troubleshooting Brake Controller Installations
- Q&A: Trailer Turn Signals Both Blink when Just Left Turn Signal is Activated
- Q&A: Trailer Lights Left Side Turn Signal and Brake Lights Not Working
- Q&A: Troubleshooting No Running Lights on Trailer but Turn Signals and Brake Lights Work
- Q&A: Checking Trailer Lights Without Hooking Up to Vehicle?
- Q&A: Troubleshooting Lack of 12V Power at 7-Way Trailer Connector on 2019 Ford F-150