Troubleshooting Trailer Running Lights Not Functioning on a 2015 Nissan Xterra
Question:
I have a 2015 Nissan Xterra. For some reason I cant get my park/running lights to work on my trailer,but everything else works great.
asked by: Omar R
Expert Reply:
First thing you should do at this point is test the 4-way of the wiring harness with a circuit tester part # 3808 for voltage on all of the right pins when the taillight signals are being applied. Just like in the video I attached.
If the voltage checks out there but the trailer lights still don't function right then the problem is on the trailer wiring. That would mean that problem is either due to a ground issue or a short issue.
Make sure that the trailer side connector are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces. The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
If the problem is on the vehicle side then I would first recommend you double check how the harness is installed on your vehicle, make sure all of the connections are good and tight. You should check all towing related fuses and relays as well. Nissan typically uses several relays for trailer wiring so that would be where the problem is most likely located. The blue relay from the Curt Relay Kit # C57000 would be the correct replacement. Typically, this relay is under the dash near the steering wheel.
Products Referenced in This Question
Curt Relay Kit for Nissan Armada or Titan Aftermarket Tow Package
- Accessories and Parts
- Trailer Wiring
- Relays
- CURT
more information >
Product Page this Question was Asked From
T-One Vehicle Wiring Harness with 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Adjusting Dexter 10K Electric Trailer Brakes
- Q&A: Which Bolt Locking Hitch Pin Can be Keyed to a 2014 GMC Sierra 1500
- Q&A: Will Bolt Trailer Hitch Lock part # BL7023582 Fit 2-1/2 inch Hitch on a 2011 GMC Sierra
- Q&A: Does BOLT Trailer Hitch Receiver Lock For GM Center Cut Key Fit 2021 Chevy Silverado
- Q&A: Troubleshooting 2017 Toyota Tacoma Sending Power Only to Trailer Right Side Tail Lights
- Q&A: Replacement Control Unit for a Kwikee Steps 909508000 Controller
- Article: Where to Position the Trailer Axle?
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Factory Brake Controller Wiring Harness Location on a 2015 Mercedes Sprinter Motorhome
- Article: Surviving the Night in a Teardrop Camper...During a Winter Storm
- Article: Trailer Hitch Receiver Sizes
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)