Ramp Lift Springs for a Trailer with a 7 Foot Long and 2 Foot Wide Steel Ramp
Question:
Hi, I have a gooseneck trailer ramp 7 ft. long by 2 ft. wide made from standard weight 4 in. channel. If I mount two of your springs on one ramp will it lift it? I dont mind lifting lifting 30 or 40 lbs. if necessary. best Regards
asked by: Ron N
Expert Reply:
If your 7-foot long and 2 foot wide ramp is heavy enough then you would use ramp springs such as # RS16933LH and # RS16933RH. But each of these springs produces 2,000 foot pounds of torque so they may be way too strong for your ramp. If you can tell me how much the ramp weighs I can determine if these springs would be a good fit.
Based on the material and size I am willing to say the ramp is probably too light for this type of spring. Another option that could work for you is the trailer tailgate lift assist # RA-27C or the Gorilla-Lift, # GL1. They just have to be mounted at the right height and the will help with raising the ramp on the trailer. I have linked a couple of review videos for you.
Products Referenced in This Question
Gorilla-Lift Utility Trailer Tailgate Lift Assist w/ Cable - 300 lbs
- Tailgate
- Trailer Tailgate
- Tailgate Assist
- Manual
- Yellow
- Gorilla-Lift
more information >
Rack'Em Double Barrel Utility Trailer Tailgate Lift Assist w/ Chain - 200 lbs
- Tailgate
- Trailer Tailgate
- Tailgate Assist
- Manual
- Gray
- RackEm
more information >
Ramp Spring - 2K Torque for 1-1/2" Shaft - RH
- Trailer Ramp Springs
- Single Ramp Spring
- Right Hand Spring
- 10 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Product Page this Question was Asked From
Ramp Spring - 2K Torque for 1-1/2" Round Shaft - LH
- Trailer Ramp Springs
- Single Ramp Spring
- Left Hand Spring
- 11 Inch Wide Spring
- Steel Alloy
- Redline
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Seal With Dimensions to Replace 171255UC
- Q&A: Solution for Squeaky/Noisy Trailer Suspension with Equa-Flex Equalizers
- Q&A: Is Bow in 3,500 lb Trailer Axle Enough Camber for Loaded and Unloaded Trailers
- Q&A: How Much Upward Bend Should Trailer Axle Have
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Wiring Diagram for Bargman 7-Way RV Style Connector # WG54006-043
- Q&A: 7-Way Furrion Power Adapter Fix For 2021-2022 Chevrolet/GM Trucks
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Calculating Portable Generator Power Needs
- Q&A: Ceiling Garnish For a Dometic Fantastic Roof Vent Fan Model 1450
- Article: Trailer Tire Sizing
- Article: RV and Camper Types, RV Classes
- Article: Double-Eye Trailer Suspension System Review