Can Ultra-Fab 2 inch Motor Home Trailer Hitch part # UF35-946402 Install on Aluminum Bumper
Question:
I believe Jeffrey showed a picture of this receiver over an aluminum cap on the bumper. It shows it with the white flexible strip in the middle, so I assume it would be no problem with my 5th wheel bumper with that has the exact same aluminum trim cap on it?
asked by: Steven
Expert Reply:
The trim piece you mentioned that is on your aluminum bumper is a fairly common style of bumper that the # UF35-946402 will fit on just like in the picture you referenced.
You will want to check with the manufacturer of your trailer to determine if the bumper is rated for having a hitch like this installed on it.
I attached a review video for this hitch for you to check out as well.
Product Page this Question was Asked From
Ultra-Fab 2" Motor Home Trailer Hitch Receiver for 4" x 4" Bumpers - 3,500 lbs
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 100 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Recommendation For Increasing Strength of Rear Bumper Attached to Spacers Off Of Trailer Frame
- Article: How to Carry Bikes While Towing a Travel Trailer
- Q&A: Replacement Grease Seal for a 168255TC Rubber Coated Seal
- Q&A: Replacement 250-031468 Seals Needed for Reliable Oil Bath
- Q&A: SuperSprings Custom Stabilizer and Sway Kit For a 2004 Chevrolet Silverado 2500HD
- Q&A: Can Single Wire Clearance Light Be installed To Replace 2-Wire Light On Travel Trailer
- Q&A: Will the Replacement Red Lens # A42RB Replace Do Ray SS-105
- Q&A: Replacement For Axxera AV615BHM RV Stereo
- Article: Trailer Tire Sizing
- Article: Best Bike Racks for Electric Bikes
- Article: How to Charge a Dump Trailer Battery
- Article: How to Choose the Right Trailer Hitch Class
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: What is an RV-Approved Bike Rack? (And Do You REALLY Need One?)