Where to Find Stop Light Circuit for Installing Brake Controller in a 2008 Saturn Vue
Question:
When installing a Tekonsha P3 brake controller, the instructions direct that the red wire from the controller is connected to the cold side of the brake switch. I am wiring mine up to a 2008 Saturn Vue but both sides of the switch are hot when the brakes are not activated. The purple wire lt blue in the schematic is cold when the brake is depressed. Does this mean that I will have to install a relay to flip the signal cold when not depressed and hot when depressed? Also, is there any way to test the brake controller output without connecting a trailer? I just want to ensure that my installation is correct. Thanks,
asked by: Jeffery K
Expert Reply:
This question comes up more frequently for the Chevy Equinoxes, but the solution is the same for the Saturn Vues.
To get it under the dash you need to access the BCM (body control module). It is located under the dash above where your left knee would be. The module will have several different wire connectors that plug into it.
It could be connector 2, pin 30 or it could be position 11. One thing that seems to be constant on the vehicles affected is that the wire is usually white so you might want to start with those.
The same rules apply for the locations at the BCM: you need the one that only shows power with the brake pedal pressed and not at any other time.
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: How Do I Measure the Drop Distance on a Trailer Drop Axle?
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Recommended Dexter Suspension Kit 7753400