Trailer Turn Signals Not Working with 2015 Chevy Traverse with 7-Way Connector Installed
Question:
Hi I just installed the trailer wire harness that I bought from you. I followed the instructions and did everything properly. I hooked up to my trailer and I have running lights and brake lights but no turn signals. Do I need to do anything else?
asked by: Dave
Expert Reply:
The trailer connector you purchased, # 118271, is designed to fit if your 2015 Chevy Traverse came with a factory tow package. If it did not come with the factory tow package then it is possible that some functions will not work.
I checked the owner's manual for the 2015 Traverse and apparently in the under-hood fuse box there are 2 fuses each for trailer turn signal/brake lights. Two of them are labeled LT TRLR STOP/TRN and the other two are labeled RT TRLR STOP/TRN. You can check those fuses.
But the fuses have both the brake light and turn signals on them so, in other words, if it was a fuse then neither the turn signal nor brake light would work.
It is possible that the issue is on the trailer. The first thing you can do is test the newly installed vehicle side connector using a circuit tester such as # PTW2993 while someone goes through the lighting functions in the vehicle. If everything works, then then issue is on the trailer.
If the issue is on the trailer, it is likely a ground problem. Ground problems normally show up when there is more draw on a system such as when you have the running lights on and then use another function like a turn signal or brake light but can show up any time.
Make sure that the vehicle side and trailer side connectors are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion free bare metal surfaces.
The light grounds should also be attached to clean and corrosion free bare metal surfaces. If there is anything between a light ground and the metal trailer frame or if the trailer has an aluminum frame, tilt bed, or folding tongue, any of these things can interrupt the ground. Running jumper wires from the light grounds to the main trailer connector ground can help.
Products Referenced in This Question
Product Page this Question was Asked From
T-One Vehicle Wiring Harness for Factory Tow Package - 7-Way Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- No Converter
- Custom Fit
- 7 Round - Blade
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Dexter Trailer Idler Hub Assembly for 6,000-lb E-Z Lube Axles - 6 on 5-1/2 - Galvanized
- Search Results: marine hub
- Search Results: 76511
- Search Results: 521567~4
- Search Results: 9332
- Search Results: hispec
- Search Results: hi spec wheels
- Shop: Americana Aluminum Mod Trailer Wheel - 15" x 6" Rim - 6 on 5-1/2
- Search Results: trailer leaf spring suspension
- Q&A: Replacement for Dexter Grease Seal 010-019-00
- Shop: Replacement Master Cylinder Assembly for Dexter Model 6 Brake Actuators - Drum
- Shop: Double Lip Seal for 3,700-lb Marine Hubs
- Shop: Replacement Master Cylinder for Dexter Model 6 Drum Brake Actuators
- Shop: Lippert RV Entry Screen Door Latch - RH
- Shop: Curt Hitch Receiver Reducer Sleeves - 3" to 2-1/2" or 2"
- Q&A: Battery Disconnect Needed When Flat Towing a 2017 GMC Sierra 1500
- Q&A: Parts Needed to Flat Tow a 2014 Chevy Silverado 1500
- Shop: Trailer Wiring
- Q&A: Troubleshooting Right Side Turn Signal Not Working On Trailer
- Q&A: Working Running Lights, But No Turn Signals or Brake Lights On Trailer
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Q&A: Recommended Towing Components for 2015 to 2017 Chevy Traverse
- Shop: Trailer Hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Wiring a Camper Shell Third Brake Light on a 2017 Chevrolet Silverado
- Video: Choosing the Right Trailer Wiring
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Shop: Brake Controller
- Video: Choosing the Right Brake Controller