Replacement 7-Way Recommendation for a 2015 Chevy Silverado 2500

Question

Question:

will this fit a 2015 Silverado 2500HD? And is it simply plug it in and it works?

asked by: Rick

0

Expert Reply:

The Twist-in, 7-Pole, RV-Style Trailer Connector # PK11916 that you referenced has been confirmed as a fit for your 2015 Chevy Silverado 2500 so it would work well as a replacement.

It will need to be mounted to the twist in 7-way port at the rear of your truck and then the connector for the 7-way behind the bumper will need to get plugged into it.

I attached an install video that shows this as well.

expert reply by: Jameson C

0

Answer 1

Thank you for the information. You will need the short arm replacement assembly (which is the following part number): **Replacement Short Arm Assembly for RV Awnings - 63" Long - Black #LC404523.

view full answer...

Answer 2

The correct replacement for your 1-065-041012-01 motor is part #LC141893 from Lippert. Your original motor had a 7140 rpm speed. The Stromberg-Carlson #LG-196308 you specified has a 5430 rpm output, so it wouldn't be a good choice. You'll…

view full answer...

Answer 3

The correct replacement for an Atwood Water Heater GC6AA-9E is the Dometic RV Water Heater part #DMC74FR. This is a 6 gallon water heater that works with both gas and electric just like the one you have so it will be an exact match.

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 7

Lance does have a proprietary plug, but many customers see a standard 6-way or 7-way round and notice it doesn't fit their factory 7-way as well. I've attached an article to help if you have one of the 7-way or 6-way round connectors which we…

view full answer...

Answer 8

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 9

I spoke with Furrion about the Furrion Microwave FMSMA15-SS and they informed me that the Furrion Over the Range RV Convection Microwave part #FMCM15SS is the correct replacement. I verified all of the dimensions and power ratings for you as well to…

view full answer...

Answer 10

You are correct that this refrigerator does not have an ON/OFF switch or function. The best you can do is "Standby" that draws an unknown amount of power. One option is to pull the 12-Volt fuse at the RV power center. A much better option…

view full answer...

Answer 11

The Lippert 2420801 hub is an 8k hub with an 8 lug bolt pattern so for a replacement you'd just need the part #8-285-10UC3-A.

view full answer...

Answer 12

Sorry Jennifer, I am a bit confused as you were looking at the Replacement U-Clamp Bracket #RM-B141 which mounts with bolts and not U-bolts. This part works with the Split Bushing #RM-205217-10 for the discontinued Roadmaster Front Anti-Sway Bar…

view full answer...