Will Curt RV Bumper Hitch with 2 Inch Receiver fit my North Trail by Heartland RV
Question:
Will your E-100 RV trailer hitch receiver fit on my North Trail by Heartland RV trailer?
asked by: Barry
Expert Reply:
The Curt E-100 Trailer Hitch Receiver is meant to be used on 4 inch square channel bumpers. You will need to measure your bumper and check to see if it is 4 inches square.
The maximum capacity of this hitch is 350 pounds tongue weight and 3,500 pounds gross towing weight. Check the owner manual of the trailer and see what the bumper capacity is. If it is less, you must abide by the lower number.
Make sure whatever bike rack or cargo carrier you will be using is built for use on the back of RVs and trailers. This hitch is not recommended for a tandem tow setup.
Product Page this Question was Asked From
Curt RV Bumper 2" Trailer Hitch Receiver
- RV and Camper Hitch
- Bumper Mount Hitch
- 4 x 4 Inch Bumper
- 350 lbs TW
- 3500 lbs GTW
- 2 Inch Hitch
- Bolt-On
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Carry Bikes While Towing a Travel Trailer
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Hitch Receiver do You Recommend for My 2022 Grand Design Imagine 2600RB Travel Trailer?
- Q&A: Recommended Weight Distribution System For 2003 Nissan Xterra With Small Tent Trailer
- Q&A: Does The Progressive Dynamics PD4655V Have A Lithium Jumper
- Article: Best Bike Racks for Electric Bikes
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: How Much Does the Kuat Transfer V2 Weigh?
- Q&A: What Is the Wire Size On the Go Power RV SAE Port for Portable Solar Panels
- Q&A: Will 8 Lug Spare Tire Fit on Curt Trailer Hitch Mounted Spare Tire Carrier
- Q&A: What is the Difference Between a Class II and a Class III Hitch?