Parts Needed to Add Brakes to a Motorcycle Trailer

Question:

What bearings kits, hubs and grease caps are available at eTrailer for Kendon Motorcycle Trailers? What needs to be done to add trailer brakes to these trailers?

asked by: VCheng

Helpful Expert Reply:

First thing you need to check is the spindles of your trailer to see if they have brake mounting flanges on them. A brake mounting flange will look like a plate welded to the back of the spindle. See picture I attached.

Next you will need to determine what hubs would fit the spindles you have. We don't have specific fit info for your trailer but we can help you figure out if we have something that would fit.

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information. The first thing you will need to know is the bolt pattern of your hubs. This is so you get a hub that is compatible with your wheels. I attached an FAQ article on determining bolt pattern for you to check out.

Next thing you will need to know is what spindle you have on your trailer. In order to do that you can either get the inner and outer bearing numbers from a hub or use a dial or digital caliper to get exact measurements of the spindle. The measurements needed are the parts of the spindle where the bearings ride.

If you get back to me with that information I will help you pick out the right hub assemblies. Or, you can follow the link I attached that will take you to the page that has all of our replacement hubs.

You would want to first select the bolt pattern that you have, next select the inner bearing you have, followed by selecting your outer bearing, and then all the correct hubs will be listed.

I attached a help article on adding brakes to a trailer that will walk you through the entire process as well.

expert reply by: Jameson C