How to Remove and Replace Lens on Optronics Pedestal Mount 3-Function Trailer Light ST51RB
Question:
A posted QandA session states Yes, there is a way to get a part # ST51RB with an amber lens. What you will need to do is replace the current lens on it with a # A52AB. The lens snaps off and the new one will snap on in its place. Im trying to gain access to the bulb but fear breaking my light. Can you please elaborate on how the lens snaps off ?
asked by: Jay R
Expert Reply:
In order to show you how to remove and replace the lens on the Optronics Pedestal Mount 3-Function Trailer Light ST51RB I pulled one from our warehouse. For reference, this light uses replacement incandescent bulb 2057, available at automotive supply stores.
If you refer to the linked video you will see that we found the best way to remove the lens was to use a pry tool. In this case we chose to use a plastic bottle opener since its less likely to damage the lens than a steel screwdriver blade. You'll want to apply firm pressure of the tool into the gap between the lens and housing. Once you have the tool's edge inserted simply twist to apply upward pressure on the lens. It should pop right off since its held on by a single raised ridge on the inside surface of the lens.
Both the replacement red lens # A52RB and the replacement amber lens # A52AB will simply press-fit back into place and snap into position with slight hand pressure. No tool is needed to re-install the lens.
Products Referenced in This Question
Replacement Lens for Round Trailer Clearance and Side Marker Light - Amber
- Accessories and Parts
- Trailer Lights
- Light Lenses
- Round
- Amber
- Optronics
more information >
Replacement Tail Light Lens for ST51RB and ST52RB - Red
- Accessories and Parts
- Trailer Lights
- Light Lenses
- Round
- Red
- Optronics
more information >
Product Page this Question was Asked From
Optronics Single Face Trailer Tail Light - Stop, Turn, Tail - Round - Red Lens
- Trailer Lights
- Tail Lights
- Stop/Turn/Tail
- Round
- Pedestal Mount
- Non-Submersible Lights
- Incandescent Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Hub Assembly for T.D.E. 11033
- Q&A: Replacement Center Hanger for Dexter 10k General Duty Axle
- Q&A: How to Choose the Correct Brake Assembly for Trailer Axles
- Q&A: Location of Fuses In Power Distribution Box To Install Brake Controller on 2008 Chevrolet Silverado
- Q&A: Potential Causes for Trailer Hub to Heat Up
- Q&A: How to Replace Blown Tail Light Bulb on Trailer
- Q&A: What are the Wiring Functions for Pedestal Mount Trailer Stop, Turn and Tail Light
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Replacing RV Awning Fabric: Your Step-by-Step DIY Guide