Fulton End Cap for a TJ507 Marine Trailer Jack
Question:
I have a old Fulton TJ507 Marine Trailer Jack that I need to replace the 2 inch end cap. Which Fulton model to you recommend to replace on my trailer?
asked by: Matt
0
Expert Reply:
The # F500323 that you referenced should work for you. Your TJ507 jack was replaced by the part # FXP10W0301 which the cap has been confirmed as a fit for.
expert reply by:
Jameson C
0
Products Referenced in This Question
Fulton Boat Trailer Jack w/ Wheel - Sidewind - Swivel - 10" Lift - Zinc - 1.2K
- Trailer Jack
- Boat Trailer
- Leveling Jacks
- Tongue Jacks
- Steel
- 1001 - 2000 lbs
- Sidewind Jack
- Swivel Jack
- 10 Inch Lift
- Weld-On
- With Wheel
- Fulton
more information >
Product Page this Question was Asked From
Replacement Endcap for Fulton Bolt-Thru Swivel Marine Jacks with 2" Tubes
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Caps
- Fulton
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Sleeve Washer for Fulton Swivel Jack to Prevent it From Leaning
- Q&A: Comparing Replacement Endcap for Fulton Bolt-Thru Swivel Marine Jacks F500323 and 500323
- Q&A: How to Install Pal Nuts on a Roller Shaft
- Q&A: ST205/75r14 Trailer Tire Vs. a ST205/75D14
- Q&A: Is There a Replacement for a Shelby Jack 5856A That Uses Existing Bracket
- Q&A: Cap Replacement to Fit Smaller Diameter Dutton Lainson Trailer Jack
- Q&A: Replacement Dust Cap For Fulton 800 Lb Jack
- Article: Trailer Wiring Diagrams
- Article: Best Boat Trailer Jacks