Instructions And Install Time For The Roadmaster XL Base Plate Kit, # 118-3, On A 1995 Geo Tracker
Question:
1995 Geo Tracker, 4x4 Auto. 2 Door no brush guard or skid plates. Gen. info on installation, and time it takes to install.
asked by: Larry M
0
Expert Reply:
To install the Roadmaster XL Base Plate Kit, # 118-3, on your 1995 Geo Tracker 4X4 2-Door it is estimated by the manufacturer to take a dealer an average of 3 hours. So if you have average mechanical knowledge I would probably allow at least a minimum of 6 hours.
There is no cutting or welding required, but it does need holes drilled into the frame rail.
I do have instructions I will email to you under a separate email that will show pictures and where to drill the holes.
expert reply by:
Jeff D
0
Product Page this Question was Asked From
Roadmaster Crossbar-Style Base Plate Kit - Removable Arms
- Base Plates
- Removable Drawbars
- Hitch Pin Attachment
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Must-Have Flat Towing Components
- Article: Roadmaster Vehicle Specific Base Plates
- Q&A: Recommended Flat Towing Equipment For A 1994 Geo Tracker
- Q&A: Everything Needed to Flat Tow a 1996 Suzuki Sidekick 2-Door Behind an RV
- Article: Trailer Wiring Diagrams
- Q&A: How do the Bikes Load on the RV Ladder Mounted Bike Carrier
- Article: Trailer Hitch Receiver Sizes
- Q&A: How To Get Replacement Arms/Tabs for Roadmaster Base Plate Kit
- Q&A: Replacement Parts Needed for Roadmaster Crossbar-Style Base Plate Kit, # 3151-1A
- Q&A: Does The Roadmaster XL Base Plate Kit # 1420-1 Include Drivers And Passenger Drawbars
- Q&A: How to Install the Valterra Waste Valve Extension Rod Kit T1046-12VP
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Guide to Choosing the Best Truck for 5th-Wheel Towing
- Article: Flat Towing Package for 2014-2018 Jeep Cherokee