Troubleshooting Brake Controller Stops Showing Power on Controller When Disconnected from Trailer
Question:
The controller will not activate the brakes at the trailer the red light comes on in the truck when I turn the key on when I touch the brake it goes out as a matter of fact I turn the key off in the red light still on without the trailer hooked the red light stays on when I touch the brake pedal without the trailer attached but if I catch the trailer I can only work the controller by hand where might my problem B I put a new plug at rear
asked by: Tim C
Expert Reply:
Testing the brake controller is fairly easy. Sever the blue brake output wire near the brake controller leaving enough room to reconnect it and then apply the manual slide. Using a circuit tester like part # PTW2993, you should get output to the controller side of the wire you severed. If the manual slide activates the trailer brake output wire properly, try the brake pedal. If the brake pedal activates the brake output properly also then the problem is farther back either in the vehicle wiring or on the trailer.
If either the brake pedal or the manual slide are not functioning properly you will need to test the wires going into the brake controller. Make sure you have power entering the brake controller on the black wire. On the red wire you will only want power when the brake pedal is pressed.
If there is power on the red wire before the brake pedal is pressed you have connected the red wire from the brake controller to the wrong circuit. You would then need to find the brake switch wire that has power ONLY when the brake pedal is activated.
If these connections check out and the brake controller is properly grounded then there is possibly a problem inside the brake controller.
I am including a link to a video that will show you how to test the wiring on a brake controller.
Products Referenced in This Question
Product Page this Question was Asked From
Curt Venturer NEXT Trailer Brake Controller - 1-3 Axles - Time Delayed
- Trailer Brake Controller
- Time Delayed Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 3 Axles
- LCD Display
- Up to 360 Degrees
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: 7-Way Trailer Wiring Harness for 2024 Hyundai Santa Cruz
- Q&A: How Does Curt TriFlex NEXT Brake Controller Mount
- Article: Trailer Wiring Diagrams
- Q&A: Mounting Panel For Redarc Tow-Pro Liberty on 2007 Toyota Tacoma
- Article: Brake Controller Installation: Starting from Scratch
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Parts Needed to Install the Prodigy P3 Brake Controller on a 2024 Honda Pilot
- Q&A: Recommended Air Bag Kit For A 2024 Toyota Tundra
- Q&A: Recommended Suspension Enhancement For A 2019 Ram 1500 Bighorn 4WD
- Article: 2 Steps for Finding the Right Weight Distribution Hitch Size
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Locating the Brake Control Plug on a 2023 Nissan Frontier
- Article: Using a Portable Generator on RV