Brake Controller Recommendation for a 2003 Dodge Ram with a 4-Way
Question:
what if my 2003 dodge only had the flat 4 pig tail, what all else will I need. I will be pulling 2 axle cargo trailer.
asked by: Mike
Helpful Expert Reply:
For converting your 4-way to a 7-way you will want the Brake Controller Install Kit and 7-Way Adapter part # 37185 and part # 3020-P. Brake (blue) wire does not run all the way back to the 4-pole at the rear; it stops at the connector that is located under the driver's side wheel well. In order to finalize the installation you must splice into this wire and continue it to the blue wire of the # 37185.
Check out the help article I attached that covers how to install a brake controller in a Dodge truck like yours.
For a brake controller I would recommend the Prodigy P2 Brake Controller part # 90195. This is our best selling brake controller because of how well it works and how easy it is to setup.
Products Referenced in This Question
Tekonsha Plug-In Wiring Adapter for Electric Brake Controllers - Dodge
- Accessories and Parts
- Trailer Brake Controller
- Wiring Adapter
- Plugs into Brake Controller
- Vehicle Specific
- Tekonsha
more information >
Adapter 4-Pole to 7-Pole and 4-Pole
- Trailer Wiring
- Wiring Adapters
- Multi-Function Adapter
- 4 Flat
- Plug and Lead
- 4 Flat
- 7 Round - Blade
- Hopkins
more information >
Product Page this Question was Asked From
Tekonsha Prodigy P3 Trailer Brake Controller - 1 to 4 Axles - Proportional
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Automatic Leveling
- Under-Dash Box
- Dash Mount
- Up to 4 Axles
- LCD Display
- Up to 360 Degrees
- Tekonsha
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Choose the Right Trailer Hitch Class
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Q&A: Trailer Suspension Hanger Kit for Slipper Springs and 38 inch Wheelbase
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Q&A: Troubleshooting A Clunking Noise Between A Fifth Wheel Hitch And Base Rails While Towing
- Q&A: Why Is 5th Wheel Trailer Clunking When Starting/Stopping with B&W Companion and MORryde Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Q&A: What is the Difference Between the Tekonsha Prodigy P2 and the P3 Brake Controllers
- Q&A: 10k Dexter Replacement Hub for a 8-415
- Q&A: Recommended Dexter Suspension Kit 7753400