Troubleshooting Install of Tekonsha Voyager Brake Controller that Does Not Brake Properly

Question:

Hi, I purchased your Tekonsha Voyager Brake Controller for my 2007 New Body Silverado . When towing my camper the brakes are touchy and engage when i tap my brake pedal but seem almost non existent when i stop faster at harder/shorter distances. Is there something i didnt adjust correctly? Thanks

asked by: Todd D

Helpful Expert Reply:

Sounds like your Tekonsha Voyager part # 39510 that you installed in your 2007 Chevy Silverado just hasn't been setup properly and that is why the braking performance isn't what you need.

Getting the braking power you need for your application is simple with the Voyager. First, set up the controller as indicated in the instructions, making sure that the internal sensor is properly leveled. Then set the overall power by adjusting the power knob while you test out your rig. The power should be just enough to achieve maximum braking without locking up your trailer brakes.

Once you have the overall power set, you can fine-tune the power output by adjusting the sensitivity of the internal sensor. Use the level knob on the side of the Voyager to achieve your desired degree of intensity. Move the knob toward you (clockwise) to delay the power output, creating braking sensitivity that is ideal for lightweight setups. If you are towing a heavy load, you may want the trailer to brake more aggressively to prevent it from pushing your tow vehicle. To get more intense stopping action, turn the level knob away from you (counterclockwise).

expert reply by: Jameson C