How Far Apart are the Mounting Holes on Replacement Mounting Bracket 40978
Question:
Can you tell me the dimension from the hole to the slot for the mounting fasteners please?
asked by: Laura
1
Helpful Expert Reply:
I went out to the warehouse and pulled Replacement Mounting Bracket # HM40978 to measure it. The mounting holes are spacing 2-3/8 inches apart on center. I have included a picture and video for this bracket for you as well.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Replacement Mounting Bracket for Hopkins 7- and 4-Pole Trailer Connector Socket
- Accessories and Parts
- Custom Fit Vehicle Wiring
- Trailer Wiring
- Wiring
- Mounting Hardware
- Brackets
- 4 Round
- 7 Round
- Pollak
more information >
Continue Researching
- Shop: Replacement Mounting Bracket for Hopkins 7- and 4-Pole Trailer Connector Socket
- Shop: Trailer Wiring
- Shop: Trailer Hitch
- Search Results: trailer coupler latch lock
- Search Results: trailer coupler lock
- Search Results: trailer tongue pin
- Shop: Master Lock Trailer Hitch Receiver Lock and Coupler Lock Set - 1-1/4" and 2" Hitches
- Shop: Master Lock Hitch Receiver and Coupler Latch Lock Set - Padlock - 1-1/4" and 2" Hitches
- Shop: LED Tail Light for Trailers Over 80" Wide - 8 Function - Submersible - 23 Diodes - Driver Side
- Video: Pollak Wiring HM40978 Review
- Video: Pollak Replacement Bracket for 7 and 4 Pole Trailer Connectors Review
- Shop: 7- and 4-Pole Trailer Connector Socket w/ Mounting Bracket - Vehicle End
- Search Results: c57202
- Q&A: How Does the Hopkins 7-Way part # HM40975 Wire to a Vehicle
- Video: etrailer Trailer Hitch Installation - 2015 Jeep Grand Cherokee
- Video: Curt Wiring - Tools for Wiring - I26 Review
- Video: Best 2016 Jeep Grand Cherokee Trailer Wiring Options
- Video: Trailer Wiring Harness Installation - 2016 Jeep Grand Cherokee HM40975
- Shop: Curt LED 4-Way Flat Connector (Vehicle End) Tester
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Shop: Base Plate for Tow Bar
- Shop: Suspension Enhancement
- Video: Hopkins 7- and 4-Pole Trailer Connector Socket Review
- Q&A: Will Hopkins 7- and 4-Pole Trailer Connector Mounting Bracket Fit Draw-Tite Hitch Bracket
- Q&A: Correct Replacement for Advent Analog Wall Thermostat ACTH1
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Ladder Racks
- Q&A: Scissor Jack Recommendation to Replaced Damaged Ones on R Pod Trailer
- Q&A: How to Determine the Correct Replacement Bearings for a Trailer
- Article: Big Truck Big RV